Most cv joints are inside of the boots on each end of the halfshaft. Easy way and least expensive way is to replace the whole halfshaft on the side that you need to replace the cv joint.
New Answer
That's okay if you're not on a tight budget.
Always support your car on a suitable stand when working underneath a car.
Tools: Various spanners, Allen keys, balljoint seperator (hard work if not), soft face hammer.
Time: 60-90 minutes.
Remove wheel, suspension arm bottom nut, toe link, hub nut.
Pull suspension arm out of the front hub you should then be able to pull the suspension leg away to allow the driveshaft through the hub (support it to avoid damaging the splines)
Remove the Allen keys from the gearbox and carefully slide the driveshaft out.
The CV end has circlips on both sides, remove these and the joint can be knocked off the shaft with a soft face hammer to avoid damage, they can be very stubborn so a vice is always handy.
Fitting is reverse but be careful not to damage any of the splines or introduce grit or grime, new boots, hub nut and new oil seals (if fitted) should always be used.
Correct torque settings and cleanliness are vital to avoid premature failure of parts.
how do you replace a CV joint on a 1992 Chevy pickup?
how do you replace the drivers side drive shaft and cv joint?
don't replace the joint. replace the axle
Replace the complete halfshaft assembly, it is much easier than trying to replace the cv joint itself.
The CV joint in a 2000 Kia Sportage can be replace by roving the tires, axle nuts, and the knuckle bolts on the struts. Next, the CV joint can be removed by placing a screwdriver between the transmission and the CV joint will pop out.
How much does it cost to replace a cv joint on 4 wheel drive
how to replace a iner left hand cv joint on a 1992 for telstar
Replace it.
no
No, replace it.
I am trying to put CV joint into differential and i need to know how to make sure it is in.
It will cost approximately $225 to replace a CV joint in your Chevrolet Avalanche. The CV joint will cost approximately $80 and require two hours of labor.