Relieve the fuel pressure at the pump switch located in the passenger compartment under the carpet of the transmission hump on the passenger side. Remove the fuel tank. Turn the lock ring counterclockwise until it's loose and remove the lock ring. Pull the fuel pump/sending unit from the tank being careful not to bend the arm for the sending unit float. Discard the old lock ring seal. Installation is reverse of removal with the following additions: (a)Apply a coat of heavy grease to the new lock ring seal to hold it in place during assembly. Install the seal in the lock ring groove. (b)Install the fuel sender/pump unit into the fuel tank so that the tabs of the unit are positioned into the slots in the fuel tank. Make sure to keep the seal in place during installation until the lock ring has been tightened properly. (c)Hold the fuel sender/pump unit in place, install and tighten the locking ring clockwise until the stop is against the retainer ring tab. - Mazda Pickups Repair Manual
chain
how do u replace alternator belt on 2002 mazda protege 5 stationwagon
timing marks on 2002 Mazda millennium 2.5 dohc
What year,what motor?? it is a 2002 Chevy avalanche 1500
how much does it cost to replace to egr valve on the 2002 mazda protege
part of the fuel pump housing,replace complete fuel pump housing
They screw in from the rear. TAke the light assy off.
I just replaced my fan belts on a 2002 Mazda Protege. It came out to a little over $200. I took my car to a Mazda dealership.
go to the library and copy instructions from a manual
You are in luck. GM has a recall on these cables and will replace them for free. Contact your local GM dealer.
On the 2002 Mazda 626 , 2.0 liter 4 cylinder and 2.5 liter V6 engines ( 105,000 miles ) according to the Gates website ( they make timing belts etc. )
Rim size: 15x6 with 5 lug and 4.5" bolt pattern Tire size: 225x70xR15