On the 2002 there is a screw from the inside of the door panel that holds the switch bezel in, so you have to remove the entire door panel.
One screw holds the door release bezel which then snaps out.
Two torx screws in the area of the door pull. There is also a screw from the bottom of the door pull holding the window switch bezel that you may wan to remove now.
There is a screw in the area of the side mirror.
Now all that holds the panel in place are tapered plug fasteners. If you start at the top front (behind side mirror) you should be able to see and release the two on the front of the panel. There are five larger ones on the bottom of the door. Continue working your way to the back of the panel. The fourth one is a little higher on the panel than the other four. Release the two on the back of the panel and the panel will lift off the top sill of the window.
Remove screw from interior of panel. There were two holding the switch bezel in. The bezel should snap out with spring clips holding it in. One front, one rear, one on each side forward of the screws.
How do I remove the back window in a 1998 Monte Carlo? how do I replace this?How do I remove from other Car's model
Changing the brake light switch in your Chevrolet Monte Carlo is quite simple. The brake light switch simply plugs in and out.
1995-1999
The 2001 Monte Carlo emergency flasher relay switch and the turn signal flasher relay switch are the same. The flasher relay switch simply plugs in and out.
you will have to replace the complete ignition switch with a new one.
no monte carlos r2door i have never seen a 2 door impala so no
where is the oil pressure switch located on a 2004 monte carlo
How do you replace the ball joints on a 1998 Monte Carlo Z34??
How do i replace the purge valve on a 1999 Chevy Monte Carlo
Begin by removing the retaining ring at the top of your 2001 Chevrolet Monte Carlo ignition switch. The ignition switch barrel will slide out. Remove the wiring harness from the end of the ignition switch. Reverse the process to install your new ignition switch.
remove pwer window switch disconnect wires. using another wire, bridge the wires in swith to complete circuit window will go up
Should be in the power distribution block under the hood My fuse box on my 2000 Monte Carlo is at the end of my dash on the drivers side..To acsess the door must be open..