How do you replace broken stud on 2001 silverado 4x4 z71?

In: Chevy Silverado

[Edit]

Answer

need to know where the stud is and what it is fastening....

Answer

soak it overnight with liquidwrench or mystery oil, then use vise grips. If stud is broke off flush, drill and use an ez-out. Be ABSOLUTELY CERTAIN that you soak it first!!!

I think you are talking about a wheel stud? If it's 4wd spin the hub assembly until it lines up with the holes in the back of the assembly (this gives room to pound it out). Next find a 5lbs short sledge hammer. Make sure the hub won't spin and pound the stud out. To install the new stud put it through the hub hole and get it started. Place washers over the other end and also the lug nut. Tighten the lug nut and as it puts pressure on the washers it will pull the stud through. -Hope that helps-

First answer by ID201795144. Last edit by Mulletmania. Contributor trust: 93 [recommend contributor]. Question popularity: 66 [recommend question]

Research your answer:

Can you answer other questions about Chevrolet Silverados?

Answers.com > Wiki Answers > Categories > Cars and Vehicles > American Cars > Chevrolet > Chevy Trucks and SUVs > Chevy Silverado > How do you replace broken stud on 2001 silverado 4x4 z71?

Our contributors said this page should be displayed for the questions below. (Where do these come from

)

If any of these are not a genuine rephrasing of the question, please help out and edit these alternates.

Silverado stud removal? How do you change a stud on chevy silverado?