To replace the crank
sensor you have to remove the harmonic balance taking special attention not to damage the pulley or the cam shaft. Remove the two 10mm retaining screws
You have to dismantle the entire engine,,,NO YOU DO NOT ITS JUST YOU HAVE TO DRAIN THE OIL TAKE THE OIL PAN OFF AND GET THAT DANG SENSOR TAKEN OUT THEN REPLACE IT!!
POSSIBLE CRANKSHAFT POSITION SENSOR.
in the distributor in the rear of the engine. sometimes known as a hall sensor
where is the crankshaft sensor located on a 1988 cutlass supreme
That year did not use are even have a crankshaft sensor.
I think you mean CAMSHAFT position sensor.
Top driver side of the bell housing.
Camshaft position is taken from the distributor, there is no separate sensor.
No it does not. It has a distributor no need for a cam sensor.
if it has a crankshaft sensor that's bad
The Crankshaft Position Sensor is your problem. Replace this and it'll fire right up.
It on the back of the coil packs going into the side of the block.