How do you replace the CV Joints on a 1990 Honda Accord?

Answer 1

You may want to go to a car parts store, or book store, and get a repair manual for your car. They cost about $16.00 Or, go to a Public Library.

If the CV boot is torn open forget about re-booting the joint, buy a remanufactured axle and replace it. If the boot is starting to crack or separate but has not torn open to the point you can see the cv joint itself you can re-boot it.

To replace the boot and/or halfshaft axle: First, remove the wheel cover and loosen the 36mm nut holding the joint to the bearing. Then raise the vehicle and remove the lower ball joint from the lower control arm and the knuckle. If your working on the passenger side, drain the transmission. Slide the half shaft out of the knuckle then use a prybar and pry the inboard end of the shaft out of the transmission or intermediate shaft, which ever should apply. Be careful not to damage the seal in the transmission. Installing the shaft is the reverse of removal. The inboard side of the shaft should snap right back into the intermediate shaft and transmission by means of a snap ring on the end of the shaft.