Search unanswered questions...
Enter a question here...

How do you replace the Starter on a 1999 Isuzu Rodeo 4WD?

[Edit]

Starter

Remove starter on a 1999 rodeo 3.2 v6 first this is no easy task you will need torches and air tools unless you really have ALOT OF PATIENCE ! Disconnect the + red post on battery. Jack up left side (DRIVER SIDE) secure vehicle with stands or blocking ! Spray the 3 bolts mounting the exhaust pipe to the manifold with a good pentrating oil.Unplug the 2 oxy. sensors on the pipe you'll be removing ( be careful not to break the clips on them) Get a thin sheet of metal cut it to fit up infront of fuel tank so no sparks can get on tank (GET A FULL FIRE EXTINGUISHER)( if you have a fuel leak you have to take care of that first!) after confiming there is no fuel or other combustibles in the area torch off the weld nuts on the rear side of the flanged pipe be careful not to damage flanges take a hammer and drive out bolts. Now move to the front of pipe room is limited i used several 3/8 drive extensions a swivel, 17 mm deep well 6 point socket with a 3/8 to 1/2 adapter hooked up to a 1/2 breaker bar.These nuts are selflocking tight little Bas*#% glow them with the torch be careful that the heat from your flame doesn't burn any wires or hoses! Key here is BABY STEPS heat it turn it heat it turn it after a full turn has been made heat it and hit it with the air rachet. You can now move the pipe down and back far enough to remove starter.Remove the 2 10mm bolts holding on shield. Remove the 2 14mm bolts holding starter to eng.for one you must slide wire loom out of the way to get on it. The starter wires one wire you must push down on top of connector to release it. the other wire is a 13mm i believe. Starter is gonna run about $150.00 Check gasket and flange area at manifold & gasket at flange at rear pipe. I applied red high heat silicone and reused mine. Used new nuts (Couldn't find flanged lockers just used regular mm nuts no washers) and bolts with neversieze. This should be done by a profesional ! LOL!

Improve Answer Discuss the question "How do you replace the Starter on a 1999 Isuzu Rodeo 4WD?" Watch Question

First answer by Ganderton. Last edit by Ganderton. Contributor trust: 1821 [recommend contributor]. Question popularity: 28 [recommend question]

Research your answer:

Answers.com > Wiki Answers > Categories > Cars and Vehicles > Asian Cars > Isuzu > Isuzu Rodeo > How do you replace the Starter on a 1999 Isuzu Rodeo 4WD?

Our contributors said this page should be displayed for the questions below. (Where do these come from)
If any of these are not a genuine rephrasing of the question, please help out and edit these alternates.
Replace starter isuzu rodeo?  Replace isuzu rodeo starter?  Isuzu rodeo starter replacement?  Replace starter on a 1999 isuzu rodeo?  Starter replacement on a 1999 Isuzu Rodeo?  Where is the starter on a 1999 isuzu rodeo?  Starter replacement for a 1999 Isuzu Rodeo?  How do you replace 1999 isuzu rodeo starter?  Starter from a 1998 Isuzu rodeo making noise?  How do you replace starter for 1999 isuzu rodeo?  How do you replace the starter on an isuzu rodeo?  How to replace the starter on a 1999 isuzu rodeo?  Where is the starter on the 1999 rodeo 4 cylinder?  How do you replace Starter of 1999 isuzu rodeo 4WD?  How do you replace a starter on an isuzu rodeo 1999?  How do you change the starter in a 1999 isuzu rodeo?  How do you replace the starter on a 1999 isuzu rodeo?  How do you replace a starter out of a 1999 isuzu rodeo?  How can you tell if starter on a 1999 Isuzu Rodeo is bad?  How do you replace a starter on a 1995 Isuzu Rodeo 4wd v6?