0
Disconnect the battery. Unplut the altenator, disconnecting the plug and taking off the belts. Unbolt the altenator, and bolt the new one on. Reconnect the belts, then the plug and finally reconnect the battery. Voila! You replaced the altenator!
Tools required: 7mm, 10mm, and 15mm sockets and 15mm box wrench or adjustable wrench.
Tips - for easier access, first remove the jack assembly, and the passenger side tension rod.
1. Disconnect the battery. 2. Release tension from the serpentine belt by loosing the bolt located to the left of the Power Steering pump (2.5L) - uses 15mm socket. 3. Belt should now easliy lift off of the alternator pully. 4. Unbolt the alternator - 15mm socket. 5. Disconnect the 5 power connectors - 7mm and 10mm sockets. 6. Remove alternator. 7. Install new alternator by reversing previous steps.
Have a new battery on hand, most likely the old one will be dead as well. Also, the serpentine belt must be VERY tight. You shouldn't be able to flip the belt over, or flex it much at all. If your engine squeals at low RPM's - tighten the belt.
Wiki User
∙ 8y ago
Add your answer:
Earn +20 pts
How much does it cost to replace an alternator in a 2006 jeep wrangler?
A lot.
Can 4 cylinder be replace with 6 cylinder in 1995 jeep wrangler?
Yes
Will a 1995 Jeep Wrangler alternator fit in a 1997 Jeep Wrangler?
I do not think so, my 89 YJ had a normal alternator belt, but my 97 TJ has a serpentine belt, so aside from any mounting differences the drive system would be different.
Is there a difference between the computer in a 1995 Jeep Wrangler and a 1992 Jeep Wrangler?
no
Can you replace the distributor of a 89 Jeep Wrangler for a 91 Jeep Wrangler?
yes
Does the 1995 Jeep Wrangler have the same chassis as the 2004 jeep wrangler?
Not exactly but close.
Where is the Jeep Wrangler slave cylinder?
how to replace the slave cylinder on a 1993 jeep wrangler
How do you replace the clutch slave cylinder on a 1989 Jeep Wrangler?
How do you replace the clutch slave cylinder on a 1989 jeep wrangler
Where is the egr valve on a 1995 jeep wrangler?
There isn't one on a 1995 Jeep Wranger.
What is the bolt pattern for a 2005 Jeep Wrangler?
Jeep Wrangler wheel lug patterns years 1995-2006 are 5X4.5Jeep Wrangler wheel lug patterns years 1995-2006 are 5X4.5
How long was the Jeep Wrangler YJ in production?
The Jeep Wrangler YJ had been kept in production for about nine years from 1986 to 1995. The Jeep Wrangler YJ marked the birth of the Jeep Wrangler series.
Will rims from a 2002 jeep wrangler fit on a 1995 wrangler?
yes.
