having trouble replacing drive cable the end of the cable is an "s" and the pulley is in the way so it is too tight to fit in whats the proper method
To replace a drive cable on a Troy Bilt self propelled lawnmower, first make sure that the lawnmower is turned off. Then, locate the drive cable and remove it according to manufacturer instructions.
replace the shift cable
If a wheel has been remove like to fix a flet, then a key. If not then the drive disc could be worn out or the belt is slipping. * If that doesn't work check to see if the bolt connecting the drive belt to the axle snapped off.
What is a driveshaft cable, your question does not sound lie you using the correct terminology
Remove the engine and drive shaft
The heater core on a 1984 Cutlass Supreme is located under the blower motor on the passenger side of the car, under the hood. First you need to remove the blower, and the hoses connecting the heater core. Replace the core, re-attach the hoses, and put the blower motor back on.
Use a GM carborate adjusting tool, it has a flex at the drive end (1/4in drive)and a 1/4in drive philups bit, if you cannot get this tool, use a 1/4 flex dtive bit driver w/philups bit.
Fix the drive belt.
If your mower is slipping while drive is engaged you may need to turn the adjusting nut at the cable entrance to the hand control. Turn the adjusting nut (cylinder) counterclockwise with a little crescent wrench. This makes the belt tighter. If this does not fix the problem then you will probably have to replace the belt and also the blade adapter and pulley. The pulley wears down with mower usage.
a cable for connecting a floppy drive to the computer motherboard.
Replace emergency brake cable Secure emergency brake pedal in its upper most position (released)
The cable connects between the motherboard of the computer and the hard-drive or optical drive.