0
How do you replace the front motor mounts on a 2000 Mercury Villager?
Wiki User
∙ 13y ago
On a lift is the easiest way because you will need to raise and support the engine while the motor mount is replaced. Once you have a new mount, I would replace both while you are at it, the procedure will become self evident. Not a difficult job.
Actually this can be done at home in your driveway in a couple hours max. Raise the vehicle on jack stands and be sure to set the parking break and block the rear tires. Then use a block of wood and a floor jack under the pulley to raise the motor just enough to take the weight off the mounts. Both the front and rear mounts are attached to the same cross member and you will need to do 50% of the job of taking out the front mount to get the rear mount out and visa versa so it is worth it to replace both if you are going to do one. Remember not to tighten them down more than snug until after the weight of the motor is back on the mounts. There are torque specifications in the front of your repair manual. Of course if you have a lift great, but for most of us do not think that you cannot do this simply because you don't have a lift.
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
How many motor mounts are on a 97 mercury villager?
Technically two. Front and rear. There are two more mounts attached to the transaxle.
How do you replace the front catylitic converter on a 2000 mercury villager?
Cut it out and weld a new one in.
How do you replace a front motor mount on a 1994 mercury villager?
Simply raise the car and support the engine on a jack, then unbolt it.
Why do your 1999 mercury villager motor mounts in front keep braking and why does it have a three second delay after putting vehicle in drive?
The motor mounts should not keep breaking if they are installed properly. The delay in the transmission indicates it needs work, probably a rebuild.
Where is the distributor on a 1998 mercury villager?
The distributor in a Mercury Villager is the round thing at the front of the engine with the six spark plug wires attached to it.
How do you replace a front wheel bearing on a mercury villager?
You will have to take out all of the parts to do this. Unless you have some experience with doing automechanics, it is a good idea to take it in.
Is Mercury villager 1997 front or rear wheel drive?
Front wheel drive
Where the thermostat is on your 1995 mercury villager?
In front of the engine, down in the "V".
Where is oil filter on 1998 mercury villager?
Bottom front of engine.
Where is the Crankshaft pulley in mercury villager?
It is on the front of the engine on the end of the crankshaft.
Where is the front motor mount on 2000 mercury villager?
At the front of the motor attached to the engine cradle.
How do you remove the front wiper arms from a 1997 Mercury Villager?
The front wiper arms on a 1997 Mercury Villager clip off once they are bent backwards. To install the new wipers simply slide them into the clip.
