Answers.com > Wiki Answers > Categories > Cars & Vehicles > American Cars > Ford > Ford Thunderbird > How do you replace the ignition module on a Ford Tempo?

How do you replace the ignition module on a Ford Tempo?

In: Ford Thunderbird [Edit categories]

Answer:

Answer

Ignition module on Ford Tempo. First things first, pull the interior trim panel off from under steering wheel, this should expose the screws from the panel on the top part of the column. You will need an inverted Torx bit to remove the old module, be sure the key is in the ACCESSORY position. The new module after market or ford part should be preset in this position as well. be sure the contacts or clean in the column and plug the new one in, pretty simple once the panels are removed and visible.

Answer

Ford Tempo uses TFI ignition, 4-cylinders used a Dist. mounted module. V-6's may be on the Dist. too. Or may be remote mounted.

First answer by ID1155752736. Last edit by ID1155752736. Question popularity: 62 [recommend question].

[report abuse]

Can you answer these Ford Thunderbird questions?

	Where is the headlight switch located?	Answer it!
	Where is the ford engine casting number?	Answer it!
	What gear to drive in?	Answer it!

Relevant answers:

How do you replace an ignition lock cylinder on a 1993 Ford Tempo?
You'll need a Phillips screwdriver to take the lower steering collar off that's right under the cylinder.Once that's off, put the key in and look on the bottom side and look for a small button. Push...
How do you replace the ignition switch on a 1991 Ford Tempo?
It is in the steering column, right behind the lock cylinder. (where you put the key in to start) You have to take the molding off of the lower column. Loosen four bolts to drop the clomn down....
How do you replace ignition switch in 1992 ford tempo?
u have to take Phillips head screws out of plastic around steering column, take screws from around instrument panel two screws at top and pop out small plastic panel on each side of steering colum on...
How do you replace the ignition switch in a 1994 Ford Tempo?
you have to take off the cover around the neck of the wheel the you will see a white plug that has a grey housing that would be your ignition switch. just unplug that and put a new one in they are...
How to replace a ignition module on a 1991 ford laser?
Take out the distributor.Take off the cap. Take off the rotor. Undo the bolt holding the bob weights. Remove the 2 screws holding the vacumatic advance unit on the outside and manouvre off the...