Ignition what? Switch? Coil?
You drill out the exsisting ignition switch!!
On a 1996 Ford Ranger : If it has the passenger side air bag deactivation switch it is located ( in the center stack of the dash , just to the left of the ashtray ) Insert your ignition key into the switch , TURN AND HOLD the switch in the OFF position while you remove your ignition key
howdo you change an ignition switch on a 1996 gmc jimmy howdo you change an ignition switch on a 1996 gmc jimmy
http://www.youtube.com/watch?v=reonxApWkVU
that switch is located in side car at bottom of stearing calum.the big wiers plug into it.
You can't, you have to replace the ignition switch
the solenoid itself is probably bad, if not that probably the ignition switch I agree 100%, check the solenoid first then the switch.
you should replace the ignition switch. You probably have too much weight on your keys, and that can wear out your switch.
1996 ranger does not have speedo cable it is electronic
Chevy Tahoe Ignition Key Starter Switch
Remove cowling from under the steering wheel, remove the two nuts holding the wheel coloum. Drop the steering coloum. Ignition switch is about a foot down on the left side. Unhook the wires remove switch replace. P.S. Unhook battery cables high voltage in ignition system.