This was on my 1998 Corolla, but the procedure should be the same. You must remove the center console to get at the burned out bulb. This can be tricky because Toyota doesn't make it easy to access...
turn the key to the on position. put car in neutral with emergency brake on. pull up th plastic housing around the bottom of the shifter( the ashstray and the comes up with it). the whole plastic...
My book says to open the hood, using a Phillips screw driver, remove the black fat top bolt holding the plastic bulb cover mounting and the cover will swing out for replacement of the bulbs. The...
There are two screws outside the car (near the trunk) and one inside the trunk behind the light that need to be removed. Then slide off th whole panel and replace the bad light.
The bulb is directly under the "PRND21" on the bottom, it is removed by a 1/4 turn counter clockwise twist. if you can't get it by reaching under the edge of the console, take 7 screws out of the...
Note: There are comments associated with this question. See the
discussion page
to add to the conversation.