0
How do you replace the power windows switch in a 2000 VW passat?
Wiki User
∙ 12y ago
You would need to take off the door panel in order to remove it. I've included an auto repair video in "related links" down below that will show you exactly what needs to be done to replace it on your 2000 Volkswagen Passat. Hope this helps you out.
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
Firebird power windows stop working and then start again?
sounds like you need to replace power window master switch
Why is my power windows and odometer are off no power?
no power on the power windows switch
2002 Passat - Fuses all OK but no wiper heater blower or HL headlight power - are there any relays I should check?
Replace the electrical portion of the ignition switch
What would cause the power windows to automatically roll up when the car is shut off on your 1990 VW Passat?
it could be that your relay is stuck on. your passat windows can be lowered or raised when car is off.
99 Volkswagen passat passenger power windows dont work Driver side works great. Replaced driver switch but no change.?
You will more than likely be needing to change the power window motor in the door. It sounds like the switch is ok. This would be the next step
Why would ac blower motor and power windows only work when ignition switch is partially engaged on 2001 dodge ram 2500?
The ignition switch is bad. Replace it.
Why does the power windows work independently but not when controlled by the drivers side switches?
more than likely you will have to replace the drivers side master switch
What is the problem when you have to turn ignition key back to get power windows to work on 99 dodge intrepid?
your switch is going out....you may need to replace it
Where is bcm located on vw passat?
The bcm that controls power windows, locks and doors is located on the driverside floor.
Camaro Z28 power windows?
Sometimes it is the switch.
How do you get your power windows to work in your 1994 astro van?
To get your power windows to work in your 1994 Astro Van, first remove the interior door panel. Now you can access the actuator, the window switch, and the window motor. Replace the broken part in order to make the windows work again.
Power windows master switch?
Check master switch If burnt or black spots or broken replace ,Check power lead wire (usually red) for cracks ,wear,etc..Replace if needed .Make sure good connect from power lead to switch.Also make sure other connections are good ,including ground connection
