You must first remove the transmission and fly-wheel. Then you will see the 1 piece
seal on the crank shaft. Pry it out, it will pop out. Then install new seal in it's place.
A seal driver is the best tool to use. Be sure you clean the area good, and put some oil on the crankshaft before sliding the seal over the crank.
You can use main bearings on a 1995 Chevy S10. The bearings can be purchased at most auto parts stores.
31 gallons main fuel tank.
1500--2 bolt, 2500 4 bolt
$2
How do you change a rear main seal on a 2001 Chevy 2500 HD long bed
The fuse for the washer pump is the same as the wipers. The fuse is in the main power distribution box.
You must remove the transmission are engine to replace the rear main seal.
get a new car!
It is integral to the main ECU
You will need to remove the transmission.
You need a wedge tool to separate the arm from the main steering rod , then unfasten the two bolts and it is off .
Pull the transmission and then replace the seal. Pick up a Haynes manual at your local Auto parts store for more detailed info.