How do you replace the right CV joint on a 1992 Honda Accord SE?

Answer

If the CV boot is torn open forget about re-booting the joint, buy a remanufactured axle and replace it. If the boot is starting to crack or separate but has not torn open to the point you can see the cv joint itself you can re-boot it.

First, remove the wheel cover and loosen the 36mm nut holding the joint to the bearing. Then raise the vehicle and remove the lower ball joint from the lower control arm and the knuckle. If your working on the passenger side, drain the transmission. Slide the half shaft out of the knuckle then use a prybar and pry the inboard end of the shaft out of the transmission or intermediate shaft, which ever should apply. Be careful not to damage the seal in the transmission. Installing the shaft is the reverse of removal. The inboard side of the shaft should snap right back into the intermediate shaft and transmission by means of a snap ring on the end of the shaft.

Improve Answer Discuss the question "How do you replace the right CV joint on a 1992 Honda Accord SE?" Watch Question

First answer by ID2363667620. Last edit by HondaGuy. Contributor trust: 127 [recommend contributor]. Question popularity: 78 [recommend question]


Research your answer:

Answers.com > Wiki Answers > Categories > Cars and Vehicles > Parts and Repairs > Steering and Suspension > How do you replace the right CV joint on a 1992 Honda Accord SE?

Our contributors said this page should be displayed for the questions below. (Where do these come from)
If any of these are not a genuine rephrasing of the question, please help out and edit these alternates.
How do you replace cv joint 1992 accord?  Replacing a cv joint on a 97 Honda Accord?  Replace cv joint boot on a 1991 honda accord?  How much is to repair cv joint for 1992 honda?  How do you replace cv joint honda accord 1993?  How do you change cv joint on 97 honda accord se?  How do you replace cv joint on 1999 honda accord?  How do you replace the cv joint on a 1992 honda accord?