hi need to know how easy or hard it is to replace the serpentine belt ,thanks
Hi, its not to difficult to change. The answers I have found on the net are all inaccurate. I just replaced mine so I will tell you what I did.
First you will have to loosen the bolt on the tension pully with a 15mm socket or a wrench if there is no room.
The tension bolt is on a bracket that is attached to the smooth pully and will be the closest bolt to the top. You will also see a 3/8 square hole on the bracket so you know this will be the correct bolt.
Once you have loosened it, you will need a 3/8 breaker bar. This will go in the square 3/8 hole on the bracket. You will then turn the bar counter clockwise and this will release the tension for you to put the belt on. Once done make sure to tighten the bolt back on and you are set to go!!
I had to do alot of the work from under the car because of the space limitations from the top.
Good luck and make sure to use jack stands if you are jacking up the car!
This diagram is under the hood. Look for it
GOOYEAR BELTS HAVE A DIAGRAM ON THE BACK OF THERE PACKAGE Sometimes these diagrams can also be found under the hood of your car. In my 1990 cavalier this sticker was located in the area where the serpentine belt goes on.
There is not a diagram under the hood showing how to replace the serpentine belt. Can you show me a diagram?
The diagram is under the hood. Pull tentioner to release tention remove belt/ replace
Remove serpentine belt. Remove alternator. The bolts that hold the tensioner on are under the alternator.
there is usually a diagram under the hood
There is a diagram under the hood on a decal
UNDER THE HOOD THERE WILL BE A DIAGRAM
The diagram is posted under the hood on the passager side.
Under hood is a diagram
There should be a belt diagram under the hood.
royal pain in the ass, look at your diagram under the hood for routing, i bought a serpentine tool, it has shallow sockets included, since theres no room on the idler.