 |
How do you replace the serpentine belt on a 2000 Windstar van?In: Ford Windstar |
[Edit] |
Answer
Well it's probably the same as the 1999 Windstar, so if it is: you need a 13mm key. It's better to have 2 people for this job: one underneath the vehicle with the key and one under the hood to remove the belt.
If I remember correctly you torque frontward and the belt will release . Hope it can help!
By the way, my van does not have the serpentine belt diagram sticker, so be sure to take a look if you have one, and if not, take a paper and mark the location of the belt through the different pullies before removing the old one.
First answer by ID1128678949. Last edit by Catvents. Contributor trust: 45 [recommend contributor]. Question popularity: 59 [recommend question]
|
Research your answer: |
- Fuel pump location of 2003 ford windstar?
- Gorge Clayman invented the seat belt?
- How do you find and replace an actuator for a 1999-2003 Ford Windstar LX climate - temperature control switch - it just clicks and the heater doesn't change temperature?
- 2003 Windstar makes a sputtering sound hard to describe then you have to hold the key on for ten seconds before the car cranks up is this the starter going bad If yes how do i replace?
Answers.com > Wiki Answers > Categories > Cars and Vehicles > American Cars > Ford > Ford Vans > Ford Windstar > How do you replace the serpentine belt on a 2000 Windstar van?
Our contributors said this page should be displayed for the questions below. (Where do these come from ) |
| If any of these are not a genuine rephrasing of the question, please help out and edit these alternates. |
