0
How do you replace the starter on a jeep Cherokee Laredo 1989?
Wiki User
∙ 18y ago
the starter is held on by two bolts. the starter is mounted to the transmission to make contact to the fly wheel. disconnect the battery and then the wires from the back of the starter and the two bolts should be easy to get to. Before you start... disconnect your ground (black) cable from your battery!
Wiki User
∙ 18y ago
Add your answer:
Earn +20 pts
How do you replace spark plugs in a 1989 Cherokee?
How to replace spark plugs in a 1989 jeep cherokee?
What is the best oil viscosity for a 1989 Jeep Cherokee Laredo?
The best oil viscosity for a 1989 Jeep Cherokee Laredo is 10w-30. This type of oil is designed to give a good balance of lubrication and protection.
What engages the axles on a 1989 Jeep Cherokee Laredo?
I believe it to be the transfer cases.
Where is the starter on a 1989 Jeep Cherokee?
The starter is on the lower passenger side of the engine.
Where can you find a serpentine belt diagram for a 1989 Cherokee Laredo?
any auto zone can print it out for you.
How do you replace the starter on a 1989 corvette?
== ==
What is the maximum size tire you can fit on a 1989 jeep Cherokee Laredo without lifting it?
31 inches
Is a 1989 Jeep Cherokee instrument cluster compatible with a 1992 Jeep Cherokee Laredo?
yes NO, The 89 uses a speedometer cable where the 92 is electronic.
While driving your 1989 Cherokee Laredo everything shut offNo power anywhere and all wiring was just replacedWhat is wrong?
Check the starter relay that is just behind the battery. The positive wire from the battery goes to it.
What type of trans fluid do you use in your 1989 jeep Cherokee Laredo it has a six cylinder with an auto trans?
dextron II
What makes a 1989 jeep Cherokee run for a few seconds then kill?
Is it possible that the Jeep is a Laredo with an alarm. My jeep did the same thing after I installed a new starter. What I had to do was close the driver side door, lock it, and then unlock it to disable the alarm. Hope this helps.
How do you replace the starter on a 1989 Toyota Corolla?
Replacing a starter on a 1989 Toyota Corolla is not very difficult to do. The wires will need to be disconnected from the old starter and labeled or taped. The starter is held in place by two bolts, unscrew the bolts and remove the old starter. Then replace with the new starter.
