Answers.com > Wiki Answers > Categories > Cars & Vehicles > Auto Parts and Repairs > Transmissions and Drivetrains > How do you replace the tail light bulb in a 2000 Dodge Dakota?

How do you replace the tail light bulb in a 2000 Dodge Dakota?

In: Transmissions and Drivetrains, Car Stereos and Speakers, Dodge Dakota [Edit categories]

Answer:

Answer

To replace the tail light bulbs in a 2000 Dakota open the tail gate. You will find two screws on each side that hold the tail light assembly in place. Unscrew these two screws then pull the assembly straight back. There are two pins holding the assembly so do not pull to the side they must come straight back.

First answer by ID1082661602. Last edit by ID1082661602. Question popularity: 63 [recommend question].

[report abuse]

Can you answer these Transmissions and Drivetrains questions?

	What other cars use a A4LD automatic transmission?	Answer it!
	What if you drive with weak transmission mounts?	Answer it!
	How much do automatic transmissions cost?	Answer it!
	How do you put a Malibu in neutral without a key?	Answer it!
	How does a person check a trans speed sensor to know if it is good?	Answer it!

Relevant answers:

How do you replace the tail light bulb on a?
Check your owner's manual first. See sources and related links below for bulb information.
How do you replace the tail light bulb?
The bulb doesn't burn out. If it goes out its broken and you need a whole new light including the lens its 1 piece. Get out of a jinkyard. The blinkers on back just change the bulb. The bird needs a...
How do you replace a tail light bulb?
Open the trunk. Pull back the carpeting directly behind the tail light that needs to be changed. Turn the bulb assembly to the left and it should come loose. Then replace the bulb and place the...
What tail light bulb do you use for a 96 dodge Dakota?
See sources and related links below for the 1996 Dodge Dakota light bulb lamp list.
How do you replace the tail light bulb on a 2000 Plymouth Neon?
Replacing a Tail Light Bulb on a Neon. This is for an 03 neon SX2 but will likely work for you. You will need only a flat head screwdriver and needle nose pliers (the pointy type pliers,...