Answers.com > Wiki Answers > Categories > Cars & Vehicles > American Cars > Jeep > Jeep Cherokee > How do you replace the water pump on a 1988 Jeep Cherokee?

How do you replace the water pump on a 1988 Jeep Cherokee?

Answer:

Answer

1. Diconnect the negative battery cable 2.Drain the cooling system 3.disconnect the hoses at the pump 4.remove the drive belts 5.remove the power steering pump bracket. 6.remove the shroud and fan 7.unbolt and remove the pump. TO INSTALL 9.clean the mating surfaces thoroughly 10.using a new gasket, install the pump and tighten bolts to 13 ft. lbs. 11.reinstall all componets in reverse order. 12.after complete operate the engine with heater control valve in heat position until the thermostat opens to purge any air in system check coolant level and fill as required.
Note: There are comments associated with this question. See the discussion page to add to the conversation.
First answer by Miss.pelling. Last edit by ID0000000000. Question popularity: 91 [recommend question].

Can you answer these Jeep Cherokee questions?

How many rotors on jeep Cherokee? Answer it!
Can you see a picture of the transmission with the neutral safety switch? Answer it!
What is the purpose of the alternator? Answer it!
Are jeep Cherokee steering boxes universal? Answer it!
When does the speedometer turn over on jeep Cherokee? Answer it!

Relevant answers:

Related topics:

  • JEEP (abbreviation)
  • Jeep (finance term)
  • Jeep (abbreviation)

Home

Answer these

Is a hamster healthier in the world or in a household?
In: Hamster Health
Answer it!
How long is the flight from cairns Australia to Chicago Illinois?
In: Flight Times
Answer it!
Do black skirt tetras eat other fish?
In: Fish
Answer it!
What was the roman god Juno known for?
In: Greek and Roman Mythologies
Answer it!
» more

Featured guides

» More