depending on engine size a 3.1 liter v6 and a 2.2 lier 4cyl. are both located in the front of the engine. remove serpentine belt,remove 4 10mm from pulley (v6)(three 13mm for 4cyl.)remove pulley.v6 will have 6 8mm bolts,4cyl. will have 4 13mm bolts-remove clean surfaces install new pump.about 20 mins.v6,30mins for 4cyl.be sure to drain coolant before you start,refill with proper coolant,some 95 up gm require dexcool anti freeze (orange in color).easy.gm Jim
== ==
0.060
the beretta and lumina motors are about the same i have a lumina motor in my 95 beretta
inside the transmission bell housing
Behind the fuel tank.
The temperature sending unit for a 1995 Chevy Beretta is on the front of the engine. It is between the front of the engine and the radiator inlet/outlet.
then there is a short some where!
In the gas. Of course.
Follow the upper radiator hose to the engine. It is behind there.
As long as the are both front wheel drive.
When you take the old one off you will see how the new one goes on. It's very simple & I've done it! Good Luck!
1-2-3-4-5-6