Answers.com > Wiki Answers > Categories > Cars & Vehicles > American Cars > Jeep > Jeep Grand Cherokee > How do you replace the water pump on a 1999 Jeep Grand Cherokee inline 6 cylinder 4.0L?

How do you replace the water pump on a 1999 Jeep Grand Cherokee inline 6 cylinder 4.0L?

In: Jeep Grand Cherokee [Edit categories]

Answer:

Answer
This is very similar to all the 4.0's out there. You will need a special set of wrenches that you can rent from Autozone then return to get all your money back. This water pump is not the funest one to do because of not having much room under between the engine and the radiator. If you have the time to pull it, then go for it.

First answer by Rdny burke. Last edit by Rdny burke. Contributor trust: 8 [recommend contributor ]. Question popularity: 70 [recommend question].

[report abuse]

Can you answer these Jeep Grand Cherokee questions?

	How do you take a seat out of a grand Cherokee?	Answer it!
	Where can you get a wiring diagram on line for a Jeep Grand Cherokee?	Answer it!

Relevant answers:

How do you replace the water pump on a 1999 Jeep Grand Cherokee?
get the right pump take in original and match blade direction also u have to remove rad
How do you replace the water pump on a 1993 Jeep Grand Cherokee?
If you are asking then it is probably best you have it replaced by a mechanic. This is fairly involved and you have ample opportunity to mess it up. on my 94 jgc limited, wi 5.2 v8, the new pump and...
How do you repair water pump 1999 Jeep Grand Cherokee?
not repair, replace. plain. make sure the inlit line is all the way in on the new pump
How to replace a water pump in 2001 grand Jeep Cherokee?
Like most engines, it is located in the block of the engine. Follow your radiator hoses to the block. The top is where your thermostat is and the bottom is where your water pump is.
How do you replace the water pump on a 1994 Jeep Grand Cherokee?
first let the engine cool, takeoff the serpentine belt, fan shroud and fan assembly off of the pulley, then unbolt the water pump, take it off clean off the old gasket. then do the reverse, put on...