On a 1996 Toyota Prado the dash board is removed & one will find a reset button with the letter "T", this button is switched off. Once this is done the T-Belt light should be reset & you will no longer see the T-Belt symbol lit up on the dash.
How to Reset Maintenance Warning Light on a 2008 Toyota 4Runner
how to reset display screen after changing oil at 15000 miles. this is on a 2008 highlander.
Where is the fuel pump inertia circuit breaker located on a 2008 Toyota Corolla
up under the dash by your right knee.
Have you tried looking in your Owners Manual, it's in there.
I have a 2008 toyota fielder and the engine check light came on .when check with a scanner code p1589 shows .where is this sensor located
where is the alarm reset switch located on the Camry 2008
please tell me how to reset the computer on a 2008 5.7 Toyota tundra. all my dash lights are on. thanks, Patrick ANSWER: all you have to do is remove the positive terminal on your battery and that should work. but be carefull while doing this as you should remove the ground first to prevent shocking/shorting.
There are a couple of ways to reset the timing belt light on a 2008 Toyota Hilux diesel. One way is to unplug the battery for up to five minutes and see if that will reset the light. If not, you can hold the trip meter button down and turn the key, but not start the vehicle. This will reset the light most of the time.
The SRS light is on because there is a problem with the Air Bags. It will be reset when the problem is repaired. This is not a DIY repair. This may very well be repaired under warranty. Take it back to your Toyota dealer for repair.
Beaverton Toyota, Oregon, provides a list of the steps to reset the service indicators for a variety of Toyota models, also Scion. Go to: How To Reset Maintenance Light ( http://www.beavertontoyota.com/service/tips.htm ) Find your make and year, and go to the list, thus ... --- "Reset Engine Oil Replacement Reminder Light" --- Find your model and follow the detailed steps. For 2008 Avalon, the list is at: http://www.beavertontoyota.com/service/pdf/08maintlight.pdf
Prees odo meter button down and turn on ignition wait 10 seconds