Before you reset the fuel pump, make sure to read all of the following instructions!!!!! ****** MAKE SURE YOU HAVE GAS IN YOUR TANK! IF IT IS EMPTY, THE FUEL PUMP MIGHT NOT NEED TO BE RESET, IT ****** ****** MIGHT ONLY NEED TO BE PRIMED, PUT AT LEAST TWO GALLONS IN THE TANK AND SKIP TO "Step 4". ****** 1.) Look for an access panel in the trunk, driver's side; it might even be labeled "Fuel Pump Reset". 2.) Open the compartment and press the red button. This should reset the pump. 3.) At this point it might be a good idea to "burp" the fuel tank. This will probably be the easiest thing you do all day! Just pop the cover and unscrew the gas cap, this will release any preasure built up inside the tank. As long as you're in a controled environment, go ahead and leave the cap open until you finish "Step 4". Otherwise "burp" it a couple of times while you're priming the lines. 4.) The next step is to prime the pump. In other words, make sure there is enough gas in the fuel lines to start the car. The easiest way to do this is by turning the key back and forth from the "OFF" to the "ON" position. *** Be sure not to turn all the way to the "START" position until you have performed "Step 4", at least 3 or 4 times. If you attempt to start the car before the fuel pump is properly primed, you will run a serious risk of burning out the pump. This could lead to even more costly repairs!!! 5.) Replace the gas cap before attempting ignition. 6.) Once you have reset the pump, burped the tank, primed the fuel lines, and replaced the gas cap; you should be all set! Go ahead and give it a crank, good luck!!!!!!!!!!!!!!!!
there is no fuel reset as in a ford.
It just " breaks " the electrical circuit so no power is flowing to the electric fuel pump until the switch is manually reset , it's a safety device
It does not have a reset or cut off switch.
THERE IS NO FUEL CUT OFF SWITCH ON YOUR CELICA
Chevrolet does not use inertia or reset switches.
The fuel pump shut off switch ( inertia switch ) opens the circuit to the electric fuel pump so that no power is going to the fuel pump when the vehicle has received a substantial jolt ( collision or maybe hitting a bad pot hole ) It is a safety device that has to be manually reset if the switch " trips "
No, Dodge does not use inertia/reset switches.No, Dodge does not use inertia/reset switches.
how do you reset the fuel cut-off shut switch on a 1995 ford econoline van?
To reset it , yes
There is no fuel reset switch on any model cobalt if i remember u can do that by disconnecting the battery for a couple of minutes.. that will reset the computer
No, a 1997 Jeep does not have an inertia or reset switch.
In order to reset a tripped fuel cut off switch you depress the red button located on the top of the switch. To locate the switch depends entirely on the year and make. Most likely its in the trunk area or in the right front kickpanel area.