You need to have the codes read. Once the cause of the code is repaired the light will clear itself.
You need to have the codes read. Once the cause of the code is repaired the light will clear itself.
You need to have the codes read. Once the cause of the code is repaired the light will clear itself.
To reset the oil warning light on a 2008 Chrysler Sebring, turn on the ignition without starting the engine. Slowly push the accelerator down three times. Next, turn the ignition to the lock position and the warning light should be gone.
No the Chrysler Sebring did not have that feature until 2008.
A scan tool or code reader is required after repairing the cause of the code.
The check engine light is reset with a scan tool after repairing the cause of the fault.The check engine light is reset with a scan tool after repairing the cause of the fault.
Key on, engine off. Press the gas pedal to the floor three times. Cycle key off and on.
Key on engine off, press gas pedal to the floor three times, cycle key off and back on.
Turn key on, engine off, press gas pedal to the floor three times. cycle key. light should be reset.
Chrysler . com
It stays on when the computer detects a malfunction in the electronic throttle system.
There is a dipstick.
It is inside the driver side fender.
It is on the bottom of the engine or transmission.