just peplace front brake pad and new sensors on my s550 mercede but the sensor light is still on how do i get it to go off
If you replaced the sensors and the light is still on, then you have a wiring issue. You will need to check the wires going to the sensors.
If it is a red circle with serrated "parenthesis" to the right and to the Left, then it's your brake warning light. The brake sensors are telling you there is something wrong with the brake system, IE: pads, fluid, sensors, etc.
remove the sensors and clean it. then put it back. if the warning light is still replace the sensors it is cheap
The vehicle does not monitor the amount of brake life you have left nor does the red BRAKE warning light indicate that pads and rotor need replacement. The red BRAKE warning indicator is meant to warn you when there is a dangerous hydraulic problem with your braking system. Take the vehicle to a professional, who know how to service an automotive braking system. On a vehicle with brake pad wear sensors, if the sensors are new, then you have a broken wire.
Change the brake pads sensors. You must change them after every brake pad swap.
yes take it to a well known parts store like advance auto parts they use a a small hand held computer to reset the warning light
If you have made the correct repairs, a short drive will clear the light.
After replacing pads and sensors, turn the ignition key on and leave on for approximately 2 minutes. This resets the brake pad wear warning light.
turn the key to position two and have the drivers door open for about 40 seconds, the light should automatically go off.. good luck.
The AOH warning light that comes on when firm pressure is placed on the brake pedal in an iveco eurocargo is usually a red brake warning light which has the word 'AoH' in the center. The letters AoH is Air over hydraulic and the warning light mean the over stroke switch has become activated in the brake chamber. The will either require the brake chamber to be bled or the front master cylinder to be replaced.
The transit brake warning light, on a Ford, can be reset by changing the brake pads. If the warning light is still on after changing the brake pads remove the fuse for 10 seconds.
The transit brake warning light, on a Ford, can be reset by changing the brake pads. If the warning light is still on after changing the brake pads remove the fuse for 10 seconds.