Look in the manual in your glovebox. I reset mine by accident when my fuel pump was dying. If you turn the key on 4. times without starting the truck, the computer goes into program mode. Anyway: from page 10 of the owners manual... Automatic door locks If this feature is selected your door locks will lock automatically if the speed is above 15 mph. This option is shipped activated and can be turned on and off by using the following procedure:
1. Close all of the doors.
2. Place the key in the ignition and cycle the key from the OFF position to the ON position for a total of four times ending in the ON position, do not start the engine.
3. Press the drivers side power door lock switch to lock the doors within 30 seconds.
4. You will hear a single chime when the programming is completed.
5. To activate the feature again, repeat the above steps.
...And from pages 12-13:
To unlock the doors and liftgate: Press and release the UNLOCK button on the key fob once to unlock the driver's door, or twice to unlock all doors and liftgate. The illuminated entry system will also come on. The system may be programmed to unlock all the doors, on the first press, using the following procedure:
1. Close all the doors.
2. Place the key in the ignition and turn the key between the OFF and ON position consecutively for a total of four times ending in the ON position (do not start the engine).
3. Press the driver's side power door lock switch to unlock the doors and within 30 seconds to lock the doors.
4. You will hear a single chime when programming is completed.
Thanks to no help from Chrysler or Dodge....I ended up figuring this one out for myself. I hope this will help you out. Start your Durango and leave it running for about two minutes. Once you do this, press both the lock and unlock button on your keyless entry (key fob) and do this three times, each time holding it pressed down for about two seconds each time. After this, your keyless entry should be reset and working. This had to be done on my Durango after I changed my battery.
Thanks to no help from Chrysler or Dodge....I ended up figuring this one out for myself. I hope this will help you out. Start your Durango and leave it running for about two minutes. Once you do this, press both the lock and unlock button on your keyless entry (key fob) and do this three times, each time holding it pressed down for about two seconds each time. After this, your keyless entry should be reset and working. This had to be done on my Durango after I changed my battery.
No. A 2004 Durango does not have a reset.
how to reset security system in a 2001 dodge durango
A 2003 Dodge Durango does not have a reset button.
No, a 1999 Dodge does not have a reset button.
On your keyless remote.On your keyless remote.
No
Dodge does not use reset switches.
A Dodge Durango does not have a reset or inertia switch.
Dodge doesn't use inerta/reset switches.
Dodge does not use inertia/reset switches.