turn the key to "on", just shy of engaging the starter. push the gas pedal to the floor fully 3 times. If this doesn't cause light to flash and reset turn off key and try again except push gas pedal 4 times. AP Anc AK
If that doesn't work;
With the key off, push and hold in the odometer button, depress the break pedal 10 times then release the odometer button.
Problem solved....
How do you turn off the change oil light on a Chevysilverado 2002
Refer to owners manual
See How to Reset the Change Engine Oil Message on page 6-18 of your "Owner's Manual", under Section 6: Service and Appearance Care - Engine Oil...
You use a scan tool after repairing the cause of the code that turned the light on.
You must have the special needed tool to reset the oil indicator light.
Leave the key in the ignition and let the anti-theft light flash. Let the key in for about ten minutes, and when the light stops flashing, the system is reset.
Chevy doesn't use reset/inertia switches.
Turn the key to on (not start) and when the dash lights come on quickly press the gas pedal to the floor three times in less than 5 seconds. This should reset the light. If not, try it again. If you have the drivers information panel you will have to go through the reset on it as described in your owners manual.
how do I replace interior light bulbs in 2002 chevy impala. I removed the cover, but the bulb is cramped in and I can't pull it out.
vice & oil reset 2002 sl500
To reset the "CHANGE OIL" light, turn the ignition switch to the "RUN" position with the engine off. Fully depress and release the accelerator pedal three times in five seconds. The light will flash twice and go out.
Insert key in the ignition, then turn the key to on position without cranking, then push gas peddle three times within 5 seconds.