Answers.com > Wiki Answers > Categories > Cars & Vehicles > American Cars > Chevrolet > Chevy Vans > Chevy Astro > How do you screw off a fan clutch from a water pump on 1996 Chevy astro van?

How do you screw off a fan clutch from a water pump on 1996 Chevy astro van?

In: Chevy Astro [Edit categories]

Answer:

Hold and loosen

There is a tool that you can buy or sometimes borrow from the parts store that is made to hold the shaft in place while you loosen the center fan bolt, I used a pipe wrench but it was a tight squeeze.

First answer by Ganderton. Last edit by Ganderton. Contributor trust: 2865 [recommend contributor ]. Question popularity: 5 [recommend question].

[report abuse]

Can you answer these Chevy Astro questions?

	How much antifreeze should be added to the radiator of a Chevy Astro Van?	Answer it!
	What is the ac enable relay?	Answer it!
	How do you install a Chevy Astro van arm rest?	Answer it!
	How do you install a Chevy Astro arm rest?	Answer it!
	How do you check alternator?	Answer it!

Relevant answers:

How do you remove fan clutch from the water pump on a Chevy astro van 1998?
One way is to get a lerge crescent wrench and adjust it around that big nut behind the fan and then after you get whatever is in the way out of it, you take a big hammer and give it the what for to...
Where is the water pump located in a 1995 Chevy Astro Van?
Look under the hood for the radiator fan. The fan is mounted to the pulley at the front of the water pump.
How do you remove fan clutch on '95 Chevy Astro van?
There are 2 types . There are 4 bolts that hold it to the water pump or there is a big nut requiring a special tool to remove.
How do I change a fuel pump on a 1996 Chevy Astro van?
The fuel pump is...................sorry to say.........in the fuel tank! First thing DISCONNECT THE NEGATIVE BATTERY CABLE FROM YOUR BATTERY!!!!!!!!!! Jack up the vehicle high enough where you...
How do you get the fan off of the water pump on a 96 Chevy van 57L?
You're probably finding that the shaft the collar nut is on spins when you try to remove it. There are several tricks. If the unit is still on - leaving the belt on for tension, heat the collar nut...