Want this question answered?
i put a header and a weber carb on mine feels like it doubled the hp
When I put a fuel pressure regulator between my stock fuel pump and carb, I found about 5psi gave me good results
Bad needle/seatvalve flooding carb.?
The g13 long block engine weighs 100 pounds The long block with intake carb etc fully dressed weighs 170 Http://www.sammypro.com
well this is most likely a carb problem, but don't rule out a loose wire. for the carb. Try setting the float bowl levels on the carb. If that doesn't work your best bet is to replace the stock carb with a Weber or sidedraft. The stock samurai carbs are junk even if you buy a new one they just don't work that good. for a wire problem check you cap and rotor and make sure there is no cracks. check the coil wire and make sure you have good contact.
my quad runner 230 has a mikuni carb on it. the only model numbers on the carb are this 35B/10.
I`ve found that in any vehicle if you can pour gas down the carb to make it run and you know the fuel pump is working (plenty of gas to the carb) than the diaphragm in the carb must have a small hole or crack which makes it loose pressure. If you rebuild the carb there will be one in the kit. Bad needle/seat valve? Float not adjusted properly?
What is stock adjustments on 86 lt250r
under the carb just ahead of the throttle plate..... 2.5 turns out from lightly seated
fuel line diagram for a suzuki quadrunner 250 from gas tank to the carb
there are many ways. one way that is easy is a turbo or super charger. also you can put higher compression pistons, get a bigger cam, hooker headers, tuned exhuast, bigger carb/fuel injection imports. etc
It has 50 hps