Remove the center nut, often you'll need to use an impact wrench so plan on getting other stuff out of the way. Borrow, rent or buy a wheel puller. There should be a couple threaded holes in the dampener pulley for you to connect the puller. The puller should easily remove the dampener pulley for you.
Good luck.
Take the belt off, take the bolt off of the idler pulley, take the pulley off, put a new one on replace the bolt, and put the belt back on
Use a socket with a long breaker bar and a gear puller.
The Watter pump is behind the main pulley that the cooling fan is attach to. take the top of the calling off and then take the fan off then the pulley. The water pump is right there. It takes 5 bolts. about a 2 hour job.
Take the belt off, take the bolt off of the idler pulley, take the pulley off, put a new one on replace the bolt, and put the belt back on
how to get the crank shaft pulley off of a 03 Hyundai elanta GLS
push the tensioner back with a 14mm, take off the belt, take off the pulley assembly
Take of the variator pulley and there should be a bolt, just take it off
Take off belt, remove bolt in center of pulley, replace with new pulley (comes with bearing). Reverse to install Take off belt, remove bolt in center of pulley, replace with new pulley (comes with bearing).
Take the drive belt off. Get a pulley removal tool and take the power steering pulley off. Disconnect hoses from the back of pump. Take support bracket off back of pump remove four bolts that are visible once you remove the pulley
yep, you have to take the pulley off using a power steering pulley puller, easily found for rental at autozone. the part that sucks is putting the pulley back on. when you figure that out, IF you figure that out, everything else will be fine.
Take off the sockets and remove the pump pulley.
take off the belt, use a pulley puller to pull it then reinstall.