answersLogoWhite

0


Best Answer

Normally I just replace it

User Avatar

Wiki User

16y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you turn a stuck water shutoff valve?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Continue Learning about Natural Sciences

Does water pressure need to build up after you turn the water valve off because you had half the water pressure you did when you turned the water valve back on to your sink?

No, water pressure is immediate. If you replaced the sink faucet you probably ended up with one of the "low flow" faucets that are being produced to save water. Sometimes they can be taken apart and "encouraged" to let more water through. if the valve had no been used in awile the gasket will stick when you turn it off and back on replace the valve with a quarter turn ball type valve and you wont have this problem again


Does the main water supply have to be turned off and the pipes drained before you can turn the screw on the pressure valve to increase the water pressure in house?

no


How do you adjust a water pressure valve to increase water pressure?

There is a bolt/screw that you turn on the top or bottom of the valve. If the pressure has decreased recently there may be issues that need to be addressed other then just increasing pressure...


Is sink water tap water?

Yes. The water going to your house comes out of a "tap," which is an open/closed valve. In a house, this is usually a faucet though the valve you turn on to get water from the house is also a tap. Water in a well or a lake does not have one, and is therefore not "tapped." Similarly, a soda fountain is tapped (since you turn it on to fill up your cup and turn it off when through), and beer that is "on tap" is poured directly into a glass instead of just opening a bottle (which is not tapped.) own as a tap.


Why would there be no water supply if the water and gas were recently turned back on in your house but now when you try to turn on the water to fill the bath tub nothing happens?

If the bath tub is the only place you are not getting water, I would check for a shut-off valve somewhere between the tub and where it branches off from the main hot and cold water lines. Or you could just have a bad valve on the tub.

Related questions

Is it normal for water shutoff valves for the sink to leak when trying to turn the water off?

No, the nut on the valve needs to be tighten. When you turn off your faucet, pressure in the line is increased and the seal in the valve is not tight enought to hold back the water. The brass or nylon coupling in the water shutoff valve may also be damaged and need to be replaced.


Can you fix a leaky faucet without turning off the water source?

you have to turn off the supply and its usually a valve under the sink. if no shutoff there then turn off the main valve which is usually at the street at the meter box.


No water flows from new bathroom faucet?

Did you remember to turn the supply line back on? Was there a plug that needed to be removed before connecting it?


How repair a stuck reversing valve?

first you have to turn the valve and see if it was just in a wrong position


How do I turn-on water supply to hot water boiler it is heating but nothing goes to the radiators?

Check your gauge to make sure you have enough pressure and your flow control valve is not stuck


How to Turn Off the Water For Plumbing Repairs Sydney?

WATER HEATER A cold water inlet pipe and a hot water outlet pipe are present in a water heater. As a result, each pipe has its own shutoff valve. The hot water exit line contains a shutoff valve that prevents all hot water from leaving the heater. If you leak any of your home’s hot water pipes, you should turn off this valve since it controls all of the hot water in your home. The cold water inlet pipe contains a shutoff valve that prevents all cold water from entering the heater from the main supply. Turn off this valve if you wish to replace or repair the heater. You must recognize each of the two valves because they are always fairly close to each other. Water heaters employ color coding to allow for such identification and to avoid mistakes. The cold water inlet valve has a blue handle, whereas the hot water outflow valve has a red handle. It would be difficult to recognize the valve that has to be closed if there was no color marking. OTHER APPLIANCES OR FIXTURES Several household equipment and fixtures rely on some type of water delivery. Washing machines, refrigerators, and dishwashers are basic equipment found in almost every home. Toilets, showers, sink faucets, and bathtubs are examples of standard fixtures. If any of these appliances or fixtures develop a leak, you should try to switch off the water to that specific appliance or fixture. Turning off the water supply locally ensures that other appliances and fixtures in your home continue to function while you replace the leaking fixture. To turn off the water, locate the fixture shutoff valve. It may vary in look and location, but it will always be adjacent to the appliance or fixture. While it is preferable to turn off the water at the source of the problem, if you cannot locate the appliance or fixture shutoff valve, you can also turn off water non-locally. Let’s take a closer look at each fixture and appliance. Washing Machines – Almost every washing machine has two water entry valves, one for hot water and one for cold water. These valves can be found in your laundry’s utility sink. These valves may be found in a recessed compartment in the wall near the machine. It is simple to turn these valves off before your washing machine is fixed. Dishwashers – The water supply tube linked to the dishwasher is frequently controlled by a shutdown valve. It can be found under the base cabinet housing your kitchen sink or near the sink faucet shutdown valves. Toilets – Because toilets only utilize cold water, there is only one shutoff valve near the floor. It is located at the bottom of the water tank, just below the water supply valve. The water supply valve is normally located towards the bottom left side of the tank. Sink Faucets – The water supply tubes are linked to the tailpieces of the faucet from beneath the sink, where the shutoff valves are positioned. There will be two valves if the faucet provides both hot and cold water. Showers and Bathtubs – Finding the shower and tub shutoff valves might be difficult. These are typically found in an access panel near the tub or shower. It is frequently located on the opposite side of the wall, in the basement under the floor, or the lower level ceiling access panel. If the main water supply line leaks someplace, or if there is no shutoff valve for the fixture that needs to be fixed or replaced, you must turn off the water for the entire house. The primary valve can be difficult to operate because it is rarely used and tends to stiffen over time. In utility space, the main shutoff valve is normally positioned near the entry of the main water line. If you can’t find it there, it’s presumably on an outside wall near the water meter. This valve should be easy to spot because it is rather big and is always situated on the house-side of the water meter. We recommend that you empty the water supply pipes by removing any standing water in the plumbing system. It will ensure that no water leaks out when the repair process begins. To accomplish this, simply follow these simple steps: Close the main valve. Turn on the smallest faucet (basement or ground-level outdoor). Turn on the highest faucet. All standing water will be drained via the water supply lines. WATER METER You could turn off the water by closing the valve on the water meter as the last option, but we strongly advise against it. The water meter is not your personal property, and it should only be utilized if your house’s main shutoff valve is broken or does not exist at all. Water meter boxes are often equipped with two shutdown valves: One on the city side of the meter. One on the customer side of the meter. Shutting off the water meter valve should be done with caution, and permission should be sought first. On the city side of the water meter, many rules prohibit homeowners from touching any part of the plumbing system


WHERE ARE THE SHUT-OFF VALVES IN A DALLAS HOME?

Whenever you want to do plumbing repairs in Dallas, whether it is to change a leaky faucet or fix knocking pipes, you need to know how to shut off the main water line, or supply. But, most homeowners do not know where their main shutoff valves are, especially if they have just moved in or are renting a home that is unfamiliar to them. The water meter, which you can usually find in your basement or just outside your home, will have a shutoff valve attached directly to it. Usually, there will be two shutoff valves – one on each side of the meter (supply and home). To effectively shut off your water supply, turn the valve located before the meter. If you need help replacing your main water shut-off valve, our Dallas plumbers can help with that too! To help, here are some common places you can look for shutoff valves in your home and how to shut off water to a house in Texas.


How do you connect domestic coil on keystoker k6 boiler to existing hot water tank system?

Connect the domestic coil thru a tempering valve to the hot water pipes in your house and turn off the valves to your old hot water heater. You should include a shutoff valve so you can revert to the hot water heater when you have your coal boiler shut down.


How do you turn off the water supply?

There should be a shutoff at the wall where the water line enters the house. There may be one before the water heater or there will be one at the water meter.


What to do if Water valve knob won't turn back on?

Isolate it from the water supply then replace the defective valve


How do you empty the water tank in the elemental workshop in runescape?

You don't, all you do is turn the right valve and then the left valve and then pull the lever to make the water wheel turn.


A ball valve is used for what?

A ball valve is used to turn water , gas or oil on and off.