i had the same problem too :(.i couldn't figure it out so what i did,is when i was done with it i turned the battarie around so it turned off
The Canon T70 camera uses Canon FD lenses. These are manual-focus lenses, but have auto exposure when used with the T70. Most FD lenses made by Canon are very high quality. They can almost always be found at modest prices through a well-known internet personal marketplace website.
No. You can't use it on Canon's autofocus film cameras either.
The short answer is: "None" See the answer for the question: Are canon t70 and canon eos rebel xsi lense compatible? The Canon AE1 takes FD mount lenses. All Canon digital cameras take EF lenses. They are not compatible.
how do i turn off the automatic TX report
the T70 uses an FD lense, which cannot be fitted onto the new range of canon digital SLR cameras which use EF and EF-1 lenses
All bayonet mount canon camera's in the past 30 years will accept an FD lens'. The AE 1 and later ones will accept the lens' but will only work on automatic if the lens has the A setting on the lens.The FD will not work on an auto focus.
Yes, the Targus Digital Camera Accessory Bundle work with a T70
you would press right on the d-pad and chose single or continues shooting
The Canon A-1 used FD mount manual-focus lenses. The earlier FL Canon lenses are also usable on the Canon A-1, but metering is a bit more cumbersome. The current Canon EF mount was introduced in 1987 for auto-focus lenses. There is no compatibility between FD and EF lens mounts. The Canons with FD mount include: Canon F-1 (1971) Canon FTb (1971) Canon FTbn (1973) Canon EF (1973) Canon TLb (1974) Canon TX (1975) Canon F-1n (1976) Canon AE-1 (1976) Canon AT-1 (1977) Canon A-1 (1978) Canon AV-1 (1979) Canon New F-1 (1981) Canon AE-1 Program (1981) Canon AL-1 (1982) Canon T50 (1983) Canon T70 (1984) Canon T80 (1985) Canon T90 (1986) Canon T60 (1990)
How do I turn enable bidirectional support on in the Canon MG2100 series properties dialg box
1: Turn off your Canon printer. 2: Remove its power cable from the power source to ensure that your printer is disconnected completely. 3: Wait at least 30 seconds. 4: Plug the power cable back in and connect the cable to the printer. 5: Turn on the printer.
Turn it 90degrees right then turn it180 degrees