The "Maint" light is a handy little thing, reminding you that it's been 45 hundred miles since your last oil change by flashing for several seconds after you start the car. At 5000 miles it gives up on the reminder and SHOUTS at you by staying on solid. Once you've finally gotten around to the oil change it's time to reset the light. It's simple.
1. Turn on the ignition key but don't start the engine.
2. Make sure your odometer is showing the 'total' mileage of the car, not one of the trip meters. Toggle to total mileage by pressing the odometer stem if necessary.
3. Turn the key off
4. Press the toggle stem and hold while turning the key on. After a couple of seconds all the numbers will disappear and will be replaced by dashes.
5. Keep holding the stem until all the dashes are gone. Hold a couple more seconds for good measure.
6. Release the stem and turn off the key. You're good to go for another 4500 miles.
Cheers
That info is in your owner's manual The dashboard light dimmer is the same stem used to toggle between and zero the trip meters (and, incidentally, reset the "Maint" light after an oil change). Just turn the stem left (lower) or right (higher) to adjust the lighting to your preference. Cheers
How do you reset maint read light on 2010 corolla
http://wiki.answers.com/Q/Toyota_rav_4_maint_required_light_2008"
WWW.VEHIX411.COM free video instructionsEvery 5,000 miles an oil change indicator light that reads, "MAINT REQD" is automatically switched on in many new vehicles manufactured by Toyota and other auto makers. This light is not an emergency, but rather serves only as a reminder that it has been 5,000 miles since your last oil change. The MAINT REQD light is basically an oil change reminder.Of course, if you get your oil changed at the dealership, they will turn off the MAINT REQD light for you, but if you change your own oil, or go to a quick lube shop, you may be stuck with this oil indicator lit. Here is a very simple four step process that should turn off the MAINT REQD light for a majority of Toyota vehicles, and possibly other brands as well (before performing this procedure, please check with your owner's manual to make sure that the MAINT REQD light is described as an oil change indicator light):• Turn your ignition key to the 'ACC' or 'LOCK' position.• Press and hold the trip meter reset nob (next to your odometer).• While holding the trip meter reset nob, turn the ignition to 'ON', but do not start the car.• Hold the meter reset until the MAINT REQD light switches offOR YOU CAN WATCH A FREE VIDEO ON HOW ITS DONE GO TO WWW.VEHIX411.COM
Maint. required light want reset.
To turn off the maint. req light (it comes on every 3k -5k mi. for oil change interval). After I change my oil I do the following: 1. depress and hold the odometer reset button 2. turn the ignition switch to on, then off 3 times (do not engage the starter), the third time the odometer will countdown "_ _ _ " then "_ _" then "_" then blank. 3. if the check engine light was just an oil change warning then the check engine light will go out.
cause u need an oil change
its in your owners manual, you hold down the odometer button for several seconds if i remember correctly
If it is the check engine light is different than the Maint req'd light (for oil changes). The MAINT REQD light is simply a timer for oil changes. Here's how you get reset the MAINT REQD light: 1) put the key to the ON position 2) press the mileage reset button on your cluster so it shows total mileage (not trip) 3) put the key to the OFF position 4) press and hold down the mileage reset button, leave it pressed 5) put the key to the ON position 6) wait until the mileage shows 000000 and you can stop pressing the ODO button
Hold down the "trip reset" button with the ignition off and keep it pressed while you turn the ignition on
How to Reset the "MAINT REQD" Light on Toyota Sienna With the car started (ignition on), set the LCD odometer readout to total mileage (not trip A or B). Turn the car off (ignition key to the OFF position). Push in AND HOLD the button/knob that switches the odometer Turn key to ON position without starting the car. You will notice the maintenance light blink and go out. Release the odometer button/knob. Turn key to OFF position. That's it! The "MAINT REQD" light has been reset to warn you to change your oil in another 5,000 or 7,500 miles or so.
Turn the 4Runner on, make sure that you are looking at the "odometer" miles and not the "Trip" miles. Turn the 4Runner off, hold the "reset" button, turn the 4Runner On and the "MAINT" light will blink 3 times. Release the "reset" button and the light will turn off. This worked great for me but the light flashed 5 times then went off. 2007 SR5 4WD 16,000 miles recently purchased from dealer hopefully there is nothing else wrong/ FYI the manual told me that the maint light is for oil change.