0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How do you test an abs sensor?
To test an abs sensor for a Lexus ES you will need to use a multimeter. The multimeter will determine if the abs sensor works or not.
Materials required to study light dependent resistors?
a resistor , two multimeter ,
Is it possible to test a diode with multimeter?
Yes it is possible to test a diode with a multimeter.
Why does resistance value measured using multimeter differ from one decoded using colour band?
Resistors have tolerance. So does the multimeter. Standard resistors range from 20% (no fourth band), to 10% (fourth band silver), to 5% (fourth band gold). Resistors will not normally measure exactly what you expect, and proper circuit design must take this into account.The multimeter may not be calibrated correctly.
What are the black and red things hanging off a multimeter?
They are called test leads, you would use them to connect the multimeter to the points that are to be tested.
How can you test a battery?
You can test a battery by using multimeter. Set the multimeter to the DC voltmeter setting and then place the leads of the multimeter across the leads of the battery. the multimeter will have a readout of the voltage.
How do you test battrey?
If you don't have a battery load tester, you'll have to use a digital multimeter to test for voltage and amperage.
How do you correctly test if a circuit is not live?
Use a multimeter and test if there is a voltage drop or current over the wire circuit.
How do you test that inverter battery is exhausted or need to be replaced?
Use a multimeter to measure the voltage.
What are some test equipment that is available for use in diagnosing and repairing communications?
Multimeter for starters
Why must a multimeter only be use to test the resistance of a deionized circuit or component?
It isn't true, a multimeter can be used for all kinds of other measurements as well.
How do you test ohm for speaker?
Use a multimeter or digital multimeter and set it to the ohmmeter mode. Put the test leads on the speaker terminals. It won't be perfect, but if it says 1.8 ohms or so then it's a 2 ohm speaker.
