I actually just did this today. I will asssume that it is a mid 90's olds or so. Anyhow, You first need to remove the clip that is connected to the blower motor itself and then remove the 6 blots from the blower motor that connect it to the firewall. Blower motors in general are not perfectly round so be aware of how it was installed in the first place. Once you remove the bolts you will just have to pull it out from the firewall and put in the new one. hopefully you have a blower motor with a clip and not a universal because splicing wires is a real pain. Put the clip back on and your good to go. If you have no idea where the blower motor is it is located up against the firewall and will stick out a little bit, It should be dead center or pretty close to center of the compartment. best of luck
They are generally located close to or near by the blower motor.
also check the AC clutch check for blown fuse... a possible bad blower motor relay
where is the blower motor located a a 1997 oldsmobile achieva
In the engine compartment. Center of the firewall behind the engine.
depends if you are doing it your self the blower is bout 100 and i did mine in a hour
The 1995 Oldsmobile Aurora blower motor relay switch is located beneath the dashboard on the passenger side. The blower motor relay switch should be labeled as such.
Depends on what Oldsmobile model you're referring to...
A motor from a 1991 Oldsmobile will fit into a 1996 Oldsmobile Delta 88. The motor mounts will need to be changed.
at is the cost to replace a blower motor on a ford focus
Blown Blower Motor fuse, defective Blower Motor Resistor Pack, or a defective Blower Motor.
Yes
Remove the wiring harness from the back of your 1995 Oldsmobile Cutlass blower motor. Remove the blower motor retaining bolts. Remove the fan from the front of the blower motor. Reverse the process to install your new blower motor.