answersLogoWhite

0


Best Answer

First prime the pump by pouring some water in the top. Then raise and lower the lever to pump out the water.

User Avatar

Wiki User

16y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How does a cast iron hand water pump work?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Value of a antique goulds cast iron water pump 1718?

waht is the value of a goulds hand water pump, cast iron red, sc 9119 made in seneca falls n.y.


How does the water flow in an old cast iron radiator?

The boiler has a circulation pump that circulate the water


How can you weld the pump case which is made with cast iron?

== ==


What was invented in order to make an engine?

Steel, lubricants, mechanical lathe, screws, nuts, carburator, oil pump, water pump, radiator, eletricity, electrical generator, cast iron, battery, distributor, coil...


What is the disadvantage of hand pump?

filtration the the water is dirty


How do you test sump pump?

Put it into a bucketful of water, it should pump. Activate the trigger by hand if necessary.


Before electricity how did people pump water?

Before humans used electrical motors to operate pumps to pump water from the ground, the pumps were mechanically operated, via hand (hand pumps), wind (windmill pumps), etc.


How do you know if your water pump needs repair?

If it is leaking antifreeze or water, or if it is making noise or binding when turned by hand.


How do you install a check valve between water pressure tank and water pressure pump?

since check valve holds water in the line can a hand pump be installed between the check valve and water tank?


How do you get the fan clutch off of a 1999 gm safari to replace the water pump?

fan clutch screws off water pump fan pump has left hand thread so to remove you need to turn clockwise


How do you get to the last 13mm bolt on a water pump without removing the whole power steering pump on a 3.8l 98 Buick Regal?

Remove the power steering pump. I just did a water pump. If you remove the top PS pump bolt and loosten the lower PS pump bolt about 1/2 way you can push the pump over with one hand while removing the water pump bolt.


Diagrams show how does a hand operated piston water pump work?

the piston is operated by the crankshaft