What is working principle and construction of bridge rectifier?

Answer 1

A full wave bridge rectifier converts AC (Alternating Current) into DC (Direct Current) with an AC component. To achieve DC only, the output of the bridge rectifier must have the AC component removed by bypassing it, usually with capacitors.

It consists of 4 diodes in a bridge format. During one half of an AC cycle, two of the diodes conduct and on the other half a cycle the other two conduct. Diodes allow current to flow in one direction only.

A diagram can be found at http://www.allaboutcircuits.com/vol_6/chpt_5/5.html

Answer 2

bridge rectifier is an electronics component that is used in a circuit to turn alternating current (AC) electricity into direct current (DC) electricity. Although there are single components that can perform this function, you can make your own bridge rectifier by creating a bridge rectifier circuit with four diodes. A diode is a radial component with a metal lead protruding from each end. The diode allows electrical current to pass in one direction, from the cathode, or positive end, to the anode, or negative end. By electrically connecting the four diodes, you can make your own bridge rectifier...

instructions:

1. • *Place the leads of four diodes through contact points in an unpopulated circuit board. Arrange the diodes in a square so that the leads can be connected together. Also, two of the diodes should have their anodes adjacent to each other, and the other two diodes should have their cathodes facing each other. The cathode ends of diodes have bars or stripes as identifying marks.
   • *Use needle-nose pliers to twist together each pair of leads. There should be four connections. As you go around your square arrangement of diodes, the twisted leads should consist of cathode-cathode, anode-cathode, anode-anode and cathode-anode.
   • *Turn on the soldering iron, allow the tip to heat up and use lead-free solder at the twisted lead pairs. Use diagonal cutters to snip off excess leads.
   • *Prepare four wires to add to your circuit. The length of the wires will depend on your planned use for your bridge rectifier. Cut the wires to your desired length, and strip a short amount of insulation from the ends. Expose enough wire at the ends to make electrical connections.
   • *Solder the input wires to your bridge rectifier. Label them as you proceed. Connect one AC input wire to the anode-cathode twisted leads. Connect the other AC input to the cathode-anode twisted leads.
   • *Solder the output wires to your circuit. The positive DC output connects to the positive AC wire input to the cathode-cathode twisted leads. The negative DC output connects to the anode-anode twisted leads.
   • *Add insulating pads to the bottom of your circuit board so it doesn't create a short circuit. Turn off the soldering iron. The bridge rectifier is ready to convert AC input to a DC output.

Answer 3

rectifier means convert ac to dc.using hwr effciency is less,but using fwr we get good effiency,because of using two diodes.the basic principle of rectifier is resonace

Answer 4

A bridge rectifier refers to a diode bridge of 4 diodes in a bridge configuration that provides some polarity of the output for either the polarity of the input or output.