when off delay timer gets control signal, its NO(NORMALLY OPEN) contact become NC(NORMALLY CLOSED) for preset duration, and then become NO.
The difference is that one is on and the other is off.
symbol of on delay timer
Timer relays are used in control circuitry. There are two main types, an (off delay) and an (on delay). If you want one device to turn off before the timer controlled device then you would use an off delay timer. If you want one device to turn on before the timer controlled device then you would use an on delay timer. When the timer is energized this starts the timer circuit in the relay to time out.
with an ON delay timer once the power has been appied to the timer unit, the timer contacts will change state-open/close after a preset time (for example A&B timers are adjustable anywhere from 0.05 seconds to 300 Hours) with a OFF delay these contacts change state after the power to the unit has been removed then the preset time will time out (this count dosen't start until the power is removed
delay timer
In the center of the dash on the left side is a timer relay. it is probably bad, causing the delay part of the lights to not work.
delay box is a term in drag racing to describe an on board timer which is a transmission brake delay timer which forces the race car to remain stationary at the starting line.
The breadmaker has a 13 hour delay timer so you can set the machine the night before and have fresh bread in the morning.
A red flashing light on the Hoover Nextra Optima washing machine when the start delay timer is set might mean that the timer itself is not operational. Run the washer on the regular cycle, and if it works fine, it is the delay timer.
It could be two things your switch for the lights is still turned on or your lights are on a timer and shut off after a twenty second or so delay.
100ms=.1 1Mhz=1000000 .100x1000000=100K timer count
A timer basically does an action every x milliseconds, this could be used to create a stopwatch function. You can set the delay time in the properties box for the object, bear in mind that you put the delay in milliseconds.