0
It goes in with the V part towards the bulb, the V keeps the bulb in place.
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
Why wont a cv shaft go back in the transmission on a 2000 for focus?
The retaining clip on the end of the axle is distorted. Replace the retaining clip with a new one. Position the retaining clip with the opening facing up when installing.
How do you change headlights on a 2004 Kia Optima?
Go behind the headlight under the hood and turn the light bulb out,there is a clip holding it in place, snapped out of it,put the new one in get the clip back on it and turn it back in the headlight house
How do you change a headlight bulb in a 91 pulsar?
you open the bonnet and then you go to the back of the headlight and youll see a wire and clip attached to the black casing unclip that wire and then unscrew the black plastic screw then youl have a clip unclip it and then pull out your light bulb and then put a new one in and put the clip back on and
How do you replace the headlight bulbs in a 2000 Pontiac Grand Am and clean out the headlight lens covers?
Remove the 8 plastic clips that hold down the plastic guard. Pull the centers out of the 8 plastic clips to remove them. Remove plastic guard. Next there are 2 clips that hold the headlight assembly in place. Push inward and pull up on the clips. The inboard clip can be removed completely, the outer clip just needs pulled up. Now you can roll the headlight assembly out of the car. Unscrew the black retaining ring around the light bulb. Unplug the electrical wires from back of old bulb. Reassemble in reverse. When putting the headlight assembly back in be sure to align the nylon pieces into the slots where the 2 clips go.
How do you remove fuel line quick connect retaining clips?
what you do is EASILY pull the hose and the retaining clip together ( like you are putting the hose back on the clip) when the hose is as far as it will go you have to squeeze the 2 white or grey retaining clip together. at the same time slowly slide the hose off. Make sure the clips are in good shape b/c if your changing the fuel pump you have to reuse them clips. Let me know if this helps you JLamond219@Yahoo.com
How do you change a headlight bulb on a 1997 Astra?
The headlight bulb easily changed. First you unplug the wires from the back of the bulb, they just pull off (this can be stiff but a screwdriver will lever it free). Then you will see a clip, squeeze the two ends of the clip together and pull it away from the fitting. Hang on to the clip, remove the bulb and put the new bulb into place, fix the clip back in by squeezing it together as before, then replace the rubber seal, finally, push the plug with the wires, on to the new bulb and you are good to go.
How do you change headlignts on a 2000 Jeep Grand Cheorkee?
Open the hood. On the back of the headlight there is a spring clip, pull this over the bulb so you can take the bulb(still plugged in ) out of the headlight itself. unplug the bulb. Plug in the new one, being carefull to avoid touching the clear glass,use the bottom plastic and the top blacked out part to plug the bulb in. Return the bulb to the headlight replace the spring clip and there you go.
How do you replace the headlight bulb located on a 2000 Nissan Altima?
go to back of headlight assembly and twist it out.
How do you change the headlight assembly Chevy Tracker 2001?
Pull out the rubber socket . No need to twist or anything, it comes straight out once you apply enough force. Then pull out the rubber boot (grab the tab at the top and pull it out from the topdown). There is a retaining clip that you need to push down to unhook one side and then pull that side of the clip like a hinged door to access the light bulb. You can then remove the bulb and replace with a similar type. Check that you orient the bulb correctly. The lamb assembly has three slots the the bulb fits in for that purpose. Then rotate the retaining clip back into position and push down slightly to latch the free end back in place. Replace the rubber boot (from the bottom up) and ensure that the bulb's electrical connector is clear. Push the rubber socket back into the bulb's connector and you're good to go.
How do you change a headlight bulb on a subaru tribeca?
How does the clip go on to hold the bulb in place? I can't see all of the bulb holder.
How do you replace the head lamps in a 73 V W Bug?
Grab the trim ring, pull it off, and you'll see a ring that retains the headlight bulb, There are five screws on it--three retaining screws, which hold it on, and two adjuster screws. Remove the retaining screws and the headlight bulb will drop out in your hand. Unplug the old bulb, plug in the new one and put the car back together. Then go to the other side and do it again.
Does the clip of the phiten go in the front or the back?
front i say
