Give it an ambien.
We do not have a timer option on the remote to place the receiver in sleep mode. The only timer options are for setting up recordings for movies and programs. Sleep mode can be setup for you TV but not the DISH receiver.
To program your DISH Network remote to your Orion TV you will simply- press and hold the TV Mode button on your DISH Network remote, until all the other mode button back lights illuminate, then release. -Now while the TV mode button is blinking enter in the remote code; 720 which is the remote code for your Orion TV. After entering 720, then press the pound (#) key. -After pressing the # key on the DISH Network remote, the TV mode button should blink 3 times and then turn off completely. This will mean the programming of the DISH remote to your TV has been completed successfully. While still in TV mode try any of the functions on the remote, such as turning the volume up or down on your TV or attempting to press the power button. -The DISH Network remote should now be programmed to control your TV. -If the remote code 720 doesn't program the DISH Network remote successfully you can also try the following using the same procedures, 220, 748, 721, or 062.
power
In order to put your DISH Network remote back into "TV Mode," you will simply need to press the clear colored button in the upper left corner of the remote that is labeled, "TV." The button will temporarily light up red & then turn off, after the light goes out you will then have successfully put the remote into TV mode.
The Power Menu
what button on PSP skips the initial setup
No. Sleep mode is a low power standby mode. No processes are taking place while in sleep mode.
sleep mode.
With a DISH Network receiver this is definitely possible, it is referred to as a "Dual-Tuner," and as long as the receiver is in Duo Mode, it allows you to watch independent programming on both TV1 & TV2. So the answer to your question is Yes, you can operate two TVs off of one DISH Network satellite receiver. Hope this helps you out!-Kirstie DISH Network
Sleep mode.
Sleep mode uses less electricity than running mode.
hold mode key of what your trying to reprogam. until all mode buttons light up. release button, it will start blinking. enter 3 or 4 digit code and press #