IPv4 goes from 0.0.0.0 to 255.255.255.255. There is a theoretical maximum of 4,294,967,296 unique addresses available, not including those behind NAT.
128 bits
what is the commercial use of ipv6?
32 bits (for IPv4), or 128 bits (for IPv6).32 bits (for IPv4), or 128 bits (for IPv6).32 bits (for IPv4), or 128 bits (for IPv6).32 bits (for IPv4), or 128 bits (for IPv6).
Short answer - yes.You need to be running Service Pack 1 at a minimum.Service Pack 2 has an even more complete IPv6 stack.To enable IPv6 on XP, open a command prompt window and type:C:\> ipv6 /?Did you then see this result?:C:\> ipv6 /?Could not access IPv6 protocol stack - the stack is not installed.To install, please use 'ipv6 install'.If you did get the above result, simply type:C:\> ipv6 installIt will take a few seconds, and then your Windows XP system will be fully IPv6 enabled.
IPV6 is relatively new and doesn't work everywhere yet.
IN IPv6 we can find 128bits.
IPv6 uses a 128-bit address space
by unchecking the check box of IPv6 in local area network properties
IPv6 address has 2^128 address and IPv6 address is of 16 bytes and is represented in colon hex notation.
By configuring an IPv6 Unicast routing command on a router you are allowing the router to communicate with the IPv6 interface. This is needed if you intend to send or receive data over an IPv6 network.
there are exactly340,282,366,920,938,463,463,374,607,431,768,211,456 ip address in the next generation internet protocol knows as IPv6 for more info visit: IPv6.com
Any host or user can get a public IPv6 network address because the number of available IPv6 addresses is extremely large.​ smb
Both 1 and 2. Also, RIPng (for IPv6).Both 1 and 2. Also, RIPng (for IPv6).Both 1 and 2. Also, RIPng (for IPv6).Both 1 and 2. Also, RIPng (for IPv6).