The average human head can turn approximately 180 degrees from side to side. However, some individuals may have greater flexibility and can turn their head further. It is important to note that forcing the head to turn beyond its natural range of motion can cause injury.
6
90
From a forward facing position, between 80-100 degrees,but can vary from person to person.
they don't turn green at all
To answer the above question is, by my knowledge, incorrect; as far as I know I cannot turn my head "all the way around." Unless I was able to snap my head, neck and spine so as to turn in a full three hundred and sixty degrees and then immediately place it back to normal free from pain, death, and abnormal change in the physical characteristics of the area surrounding my head.To answer the question that was probably meant to be asked: "Why is it that a human cannot turn their head a full three hundred sixty degrees?" I would answer that it is because of what is known as our natural anatomy. Through study, it would be completely simple to answer the exact reason as to why a human cannot perform the said action. It is obvious however, to conclude that it has to deal with the fixed position of our neck and the anatomy behind the rotation of the head.
when a vampire bites a human the human can turn into a vampire or the vampire can drink all of the humans blood and kill them
because her head can still turn people into stone so she doesn't need her body.
the equivalent of 90 degree turn on a head bolt is a right angle, 1/4 a circle
how far can humans turn there head
Turn the head and lower down the head basically
owls.., hoot,hoot (ovo) <( . )>
It is important to know the head bolt tightening sequence and the torque of a vehicle. For the Fiat Punto it is 20nm, 30nm, 90 degree turn, 90 degree turn, then in order 8,6,2,5,10,7,3,1,4,9.
there are 90 degree in a quarter turn
There are 360 degree in whole turn
A chicken can turn its head about 99 degrees
There are 60 seconds in 1 degree of a turn
EA and EB 6 cylinder head bolt torque is 40nM or 29 ft/lb PLUS a quarter turn or 90 degree turn after initial torquing.
A wrench in which One side has a 15 degree head and the other is 80 degree. Same size on the both usually. For bolts that arebhard turn in a ackward spot.
there is 180 degree in a half turn