10 lb ft
The flex plate is bolted to the back of the crankshaft. It connects the motor to the torque converter in the transmission. To replace you remove the transmission and replace it.
DextronIII
· Galaxie (Ford) · Geo (Chevrolet) · Golf (VW) · GMC · Golf (VW) · Grand Am (Pontiac) · Grand Cherokee (Jeep) · Grand Marquis (Mercury) · Grand Prix (Pontiac) · Gremlin (American Motors) · GTO (Pontiac) · GTX (Plymouth)
· Galaxie (Ford) · Golf (VW) · GMC · Grand Cherokee (Jeep) · Grand Prix (Pontiac) · GTO (Pontiac)
The correct type is 134A and should be listed as well as the capacity on a decal on the rad support or under side of the hood
Bell housing bolts and the torque converter bolts.
It is attached to the valve body inside of the transmission.
need torque specs for 3.4 pontiac grand am intake and rocker arms
Dexron III automatic Transmission fluid should be used in a 2000 Pontiac Grand AM. This can be picked up at almost any general store.
i need the torque sequence for a 1998 pontiac grand am 2.4 quad
If your dipstick reads "Full", then you do not need to add any fluid. Be certain to follow manufacturer instructions when checking fluid level. Your torque converter is part of the transmission, when speaking of fluid, so if the transmission is full, the torque converter is also.
The flex plate is bolted to the back of the crankshaft. It connects the motor to the torque converter in the transmission. To replace you remove the transmission and replace it.
yes it should bolt right up as well as the original motor and tranny
what are the torque specs for lifters on a 2000 Pontiac grand am gt
The 2001 Pontiac Grand Prix 3.8 liter engine intake bolt torque specification is 45 pounds. The intake bolts should be torqued in 15 pound intervals.
The head bolt torque specifications, for your 2002 Pontiac Grand Prix, is 160 pounds per square inch. The head bolts should be torqued in 40 pound intervals.
Torque specs for a 1996 Pontiac Grand Prix 3.1 is 185lb-ft of torque at 4,000 RPM.