It depends on the load it is under, the size of the engine, who made the engine (Honda, Tecumseh, Briggs & Stratton, etc) and I'm sure many other factors. We have 3500 watt Honda generators at work that will run 12 hours on a 2.5 gallon tank under light load (a single power tool and/or battery charger).
To calculate what devices the generator will operate, add up all of the wattage's of the devices you would like to operate. If the added load is higher than the 7000 watt output, the generator breaker will trip. If the wattage load is lower than the calculated output of the generator, the connected devices will operate.
If there is a motor being connected to the generator keep in mind that you have to use the motors full load amperage x volts to find the watts and multiply it by a factor of 3. This is because when a motor first starts, the generator will be looking at an almost dead short, with a high amperage draw, until the motor starts turning. Once the motor starts turning the amperage drops down to its normal operating amperage.
To find the wattage of the devices you want to operate, use the following equation. Watts = Amps x Volts. The device that you want to connect to the generator will have its amperage on the nameplate of the device.
A 3000 watt generator can run from 8 to 20 hours on a single tank of fuel, depending on how heavy the load is. This type of generator employs an Eco system where if the load is shut off, the generator slows down to an idle state and stays there until the load is sensed again. On re sensing the load the generator speeds up to its rated output. Since a TV is on the very light end of the load, the generator should remain operating on the top end of the hours scale.
light bulbs, refrigerator,tvs,radio,microwave, dvd, fan, ceiling fans,even a small a/c unit
A Storm Cat 800 watt generator has a decimal rating of between 190 to 265 decibels depending on load and amperage. This is enough noise pollution to cause hearing damage after twenty minutes of exposure.
Yes, 50 ft is ok provided you are using the correct AWG. You can do the following lengths for 30 Amps with a 7000 watt load - AWG - 4 = 300 ft AWG - 6 = 175 ft AWG - 8 = 100 ft AWG - 10 = 75 ft
At 240 volts, and 7 amp current, you will have a load of 1680 watts (volts x amps = watts). A 2000 watt generator will sufice, however a 3500 watt generator, if within your budget, will power a few other necessities if required.
If the 1600 represents 1600 watts like most generator numbers do, then the generator can deliver enough power to run a 1600 watt load connected to it.
The causes of over loading in generator comes from the action of applying more load that the generator is rated for. An example using a 5000 watt generator and a connected load of 6000 watts.
A 3000 watt generator can run from 8 to 20 hours on a single tank of fuel, depending on how heavy the load is. This type of generator employs an Eco system where if the load is shut off, the generator slows down to an idle state and stays there until the load is sensed again. On re sensing the load the generator speeds up to its rated output. Since a TV is on the very light end of the load, the generator should remain operating on the top end of the hours scale.
A 7000 watt generator us typically intended for 2 - 15 or 20 amp circuits at 120 volts or 1 - 30 amp circuit at 240 volts. When you say, "power a house," if you mean the whole house the answer is, No. You would need a generator capable of supplying a continuous 24000 watts or more to do that. But a 7000 watt generator is a nice one for powering some lights and your gas furnace blower during a power outage when properly connected. I do not know what the wattage is of an electric furnace to know if it can run one of those.
light bulbs, refrigerator,tvs,radio,microwave, dvd, fan, ceiling fans,even a small a/c unit
A Storm Cat 800 watt generator has a decimal rating of between 190 to 265 decibels depending on load and amperage. This is enough noise pollution to cause hearing damage after twenty minutes of exposure.
Yes, 50 ft is ok provided you are using the correct AWG. You can do the following lengths for 30 Amps with a 7000 watt load - AWG - 4 = 300 ft AWG - 6 = 175 ft AWG - 8 = 100 ft AWG - 10 = 75 ft
Most hair dryers are rated at least 800 watts to as much as 1875 watts. Given that, a 500 watt generator will NOT run a hair dryer. You would need at least a 2000 watt generator, just be be on the safe side.
A 1000 watt generator cannot run a 1500 watt ceramic heater without having problems.
At 240 volts, and 7 amp current, you will have a load of 1680 watts (volts x amps = watts). A 2000 watt generator will sufice, however a 3500 watt generator, if within your budget, will power a few other necessities if required.
An 8000 watt generator at regular house current 110v will supply 72 amps.
Yes, you can use up to 25 amps on a 3,000 watt generator.