The bulb will have an efficacy of 17-20Lm per watt, so in total 500W = 8,500-10000 lumens. However, the bulbs light output is non directional, so a lot of the spilled light is in directions that you don't want it to go, so 50-70% of the figure can be used when specing up an LED variant.
That will vary on the manufacture and quality of the bulb. There is no set amount of lumens for a 40 watt halogen or any kind of bulb for that matter. To find out the lumen output you need to look at the box it came in as it should be stated. If you don't have the box it may be tricky to find out. You will have to see if you can find the manufacture somewhere on the bulb then google it and check the specs. It's probably safe to say its going to be around 500 lumens on average.
Incandescent bulbs: 10 lumens per watt Halogens: 13 lumens per watt CFLs: 50 lumens per watt A useful bulb to light a small room is 600 lumens, so that would need a 60-watt incandescent, or a 45-watt halogen, or a 12-watt CFL energy-saving bulb. The best CFL bulbs are the spiral ones.
Yes. It just won't be as bright.
Input to light bulb is Electricity and output is light.
A jdr is a type of halogen light bulb. These bulbs have a screw in base, that is one size smaller than a standard household base.Ê
Approximately 15 lumens per watt for halogen, so 300 lumens.
It depends on the type of GU10 lamp - an GU10 LED will have a lower power usage (cheaper to run) but lower Lumen output. For example a 3W GU10 LED lamp in warm white has an output of about 150 Lumens. For a halogen GU10, a 35W bulb will have an output of about 600 Lumens. For more powerful lamps, expect a higher Lumen output. Finally you have an option such as a low energy GU10 such as the Megaman, which for a 7W power value gives an output of 620 Lumens, which exceeds that of the halogen bulb and also has a longer life.
It varies from about 600 to 1100 lumens. Typically the higher the lumens output, the shorter the lifespan of the globe. Have a look at this list of globes for purchase whih shows wattage and lumens: http://1000bulbs.com/category/75-watt-incandescent-standard-shape-light-bulbs/
Should be about 850 lumens. The same brightness is produced by a 15 watt CFL.
10-11 lumens per watt for incandescent bulbs 13-14 lumens per watt for halogen 50-60 lumens per watt for fluorescent
4800-5,950 for a T3. Most standard ones are in the 5600 to 5950 range.
From 550 to 750 lumens
It depends on the specific lamp. The packaging the lamp comes in should tell you what the lumen output is. This in a common question as people want to compare LED replacements. You can use 600 lumen as a good guide for comparison for a 50 Watt halogen.
A 150 watt halogen bulb will give off somewhere around 2000 lumens. These lights may give off up to about 2400 lumens.
Halogen lamps run hotter than conventional incandescents, and as a result of their hotter filaments, emit a whiter light with more of the light in the visible range, and less in the infrared. A typical 50W halogen emits between 800 and 950 lumens.
The lumen output of the bulb should be determined by measuring the Lumens exiting the fixture that it is installed in. The reflector, lens and housing will all affect the the amount of "light" that exits the fixture to reach the space you are intending to illuminate. Bulbs will vary and Lumens will vary based upon the voltage. A typical 12V 20W Halogen bulb will yield about 180-220 lumens depending on the lens (clear vs. frosted) and the reflector type. Lumens will drop as voltage goes below 12Volts as the design voltage is specified in order to "excite" the halogen gas as it reacts with a tungsten coated filament. If the voltage isn't high enough the filament won't reach it's design temperature and the light won't burn as bright as it was designed to. a lone bulb will yield up to 280-300 Lumens with now housing, lens or fixture but it is also very dangerous due to the heat hazard.
Wikpedia says that halogen lamps produce about 19-20 lumens/watt. If you have a 500W lamp then you get 9500-10000 lumens.