For building curtain walls: 4" T x 8" H x 16" L Building Curtain and Partition Walls: 4" T x 8" H x 16" L
what are the dimensions of one brick and the total area in sq feet then i can help you
Nominal size of a standard metric brick is 102.5mm x 65mm x 215mm
It is a nominal size. Sheet and plate steel thicknesses may vary from nominal thicknesses by up to 10%.
Nominal bore which is designation for pipe size.
Diameter drill is drilling.
Due to high strength, practically no breakage during transport and use.Due to uniform size of bricks mortar required for joints and plaster reduces almost by 50%.Due to lower water penetration seepage of water through bricks is considerably reduced.gypsum plaster can be directly applied on these bricks without a backing coat of lime plaster.These bricks do not require soaking in water for 24 hours. Sprinkling of water before use is enough.DisadvantagesMechanical bonding strength is weak. But this can be rectified by adding marble waste.Limitation of size. Only modular size can be produced. Large size will have more breakages.
NB (nominal bore) is the European designation equivalent to NPS is DN (diamètre nominal/nominal diameter/Durchmesser nach Norm), in which sizes are measured in millimeters. NB (nominal bore) is also frequently used interchangeably with NPS.You can refer more details herehttp://www.piping-engineering.com/nominal-pipe-size-nps-nominal-bore-nb-outside-diameter-od.html
Nominal size is the size of the largest aggregate in a grading.
on the basis of nominal diameter with tolerances is called nominal size, while required size is called basic size
Measure the inside diameter and that is your nominal size.
it is the nominal size?
It depends on the size of the bricks; they are not standard across the world. It depends on the size of the bricks; they are not standard across the world. It depends on the size of the bricks; they are not standard across the world. It depends on the size of the bricks; they are not standard across the world.
Nominal size is 1.00". Actual is 1.1.25" (includes deformation ribbing).
It is a nominal size. Sheet and plate steel thicknesses may vary from nominal thicknesses by up to 10%.
it depends on the size of bricks and size of the garage
It depends on the size of the bricks.
Nominal bore which is designation for pipe size.
DN": Diametre nominel - Nominal diameter of the valve, and "50" is the size of the valve in [mm]. Alternative is NPS (Nominal pipe size in inches).
It depends on the size of the bricks.