In most areas of Canada, the driller has a 'set up' fee of around $2500 - 4,000. This gets him and all his equipment to the site. After that the charge is by the foot and costs around 46 - 56 per foot drilled.
To answer this question more information is needed. The voltage and amperage or the wattage of the pump must be given. The other factor needed is the rate in kW/h you are charged from the utility company in your region. With this information a cost can be calculated.
Find the amperage that your pump motor operates on (should be on the motor nameplate) and multiply it by the voltage that the motor is connected to (120 or 240 volts). This will give you the wattage of the motor. It is usage of watts that the utility company bills you on. Find from your utility bill what you are charged per kilowatt hour. Take your pump wattage, times the amount of time that the pump runs, times the kilowatt rate you are charged by the utility company and the result will be how much it costs you to run the pump motor.
The power (in watts) can be calculated using the formula: Power (W) = Voltage (V) * Current (A). In this case, the power required to run the 3 amp well pump on 220 volts is 660 watts (220 V * 3 A = 660 W).
It costs about $22 a year, or about $2 a month. It really depends on how much you run it.
$40.00 a year
It depends on your location.
To determine the cost of electricity used by the well pump of a shared well you could: 1) run the pump's electrical wiring through a electrical meter. Electrical meters of sufficient wattage are available from many hardware stores. This method is fairly exact in finding out how much electricity the pump uses. Finding out how much of that electricity was used to pump your water vs their water can be determined by installation of water meters.
10 cents per hour
It varies from State to State and it varies somewhat between Contractors. To give you an idea, here in Florida, a 150 foot 5" well would cost you around $3000.00. The pump package for a home would run about $1800.00.
The heat pump will run around $3500 and the coil will be almost $1000. Heil is a premium brand and very expensive.
if you pump out too much water too fastdrought
The cost to replace the fuel pump in a Nissan Altima can run between $50 and $150. It depends on the year of the car, the brand of the part and where the part is bought.
AnswerThey cost somewhere aroun $5,789, and they didn't run that well. AnswerThey cost somewhere aroun $5,789, and they didn't run that well. They actually cost in the $400 - 700 range.http://en.wikipedia.org/wiki/Ford_Model_B_(1932)
Usually it's more cost-effective to buy a new water pump vs. repairing (rebuilding) the old pump. The cost of a new water pump for a 1999 Land Rover Discovery will run anywhere from $150 - $350, depending on the brand (aftermarket or OEM) and where you buy it.
Find the amperage that your pump motor operates on (should be on the motor nameplate) and multiply it by the voltage that the motor is connected to (120 or 240 volts). This will give you the wattage of the motor. It is usage of watts that the utility company bills you on. Find from your utility bill what you are charged per kilowatt hour. Take your pump wattage, times the amount of time that the pump runs, times the kilowatt rate you are charged by the utility company and the result will be how much it costs you to run the pump motor.
If your well pump has a option for a water level sensor then you can add it your pump but more then likely you will have to buy a well pump that already has one in it.
depending on conditions but generally a heat pump will cost you less to run.
if you're re-drilling a dry well and already have the pump, maybe a couple of thousand dollars at the most new installations requiring a pump, electricity, permits, etc. . .that can run alot higher