The quauntity in liters is five times the water flow rate in liter/minute.
Definitely a bath
bath
12.5 gal
Try removing and cleaning out the aerator on the sink faucet, and the shower head. (Word to the wise: if you take them apart, write down the order. It can be tricky trying to figure it out, afterwards). By just removing them, you should get hot water, thereby verifying that these are the cause of the problem. If you don't want to clean them, you can always replace them. Water saving aerators are available for faucets. Water saving shower heads are also available. Some shower heads even have on and off switches, for additional water savings. How I learned, the hard way: My situation was, hot water from kitchen & bathroom sink faucets, and even from the tub faucet, but not from the shower head. So, I removed the shower head and soaked overnight in CLR.* Cautionary note: Probably would have been OK to soak overnight in vinegar, or for a few hours in CLR. But overnight was too long in CLR. It must have dissolved more than just the calcium deposits. Now the shower head has much thicker and much more water consuming streams. (Previously it had a very stingy water conserving spray).
Anywhere from 3-5 pounds. To help reduce it drink plenty of water before and during period and limit salt intake.
You cannot drink 12 gallons of water at a time: you will throw up before you get all that down.Having said that, yes, you will die. You WILL drink more than 12 gallons of water during your life and, irrespective of how much you drink, you will eventually die.
36.6 seconds. 60 seconds = 1 minute, therefore, 0.61 * 60 = 36.6 seconds
My jacuzzi 370 hot tub how much water doae it hold?
4 gallons if head delivers 2 gallons/minute
Easy to figure out 2.2 * 8 = 17.6
A shower head would use between 60 to 75 gallons for a 30 minute shower.
It would depend on the shower speed setting
Can't say because this depends on the flow coming out of the shower head. If the flow is 1ltr per minute then in 10 minutes you will use 10 litres The average shower in the US flows at a rate of 7.9 liters per minute, or 2.1 gallons per minute. A ten minute shower would consume 79 liters or 21 gallons of water.
This is impossible to say as all showers are different.
depends on how much you want, like i have 700 gallons.
There is no relationship between millilitres and a shower.You are possibly asking how much water does it take to shower, in that case- the average shower head discharges about 1.5 - 2 gallons of water per minute.
6.3 gallons of water us used
A ten minute shower can use less water than a full bath. With a new 2.5 gallon-per-minute (low-flow) shower head, a 10-minute shower will use about 25 gallons of water, saving you five gallons of water over a typical bath. A new showerhead also will save energy — up to $145 each year on electricity — beating out both the bath and an old-fashioned showerhead. To avoid moisture problems, control humidity in your bathroom by running your ventilating fan during and 15 minutes after showers and baths.
25 to 50p depending on your water bill, gas electricity etc
An average flow rate cannot be determined as there are many different shower heads and each house in every country has different water pressure and not everyone may use full pressure when using a shower. But, approximately said that the average flow rate of shower water 2.5 gallons per minute at a water pressure of 80 pounds per square inch.